Lines Matching full:resistance

349 	int resistance;	/* internal resistance percent */  member
354 	int ri_uohm;	/* Internal resistance in microohm */
501  * @factory_internal_resistance_uohm: the internal resistance of the battery
502  *   at fabrication time, expressed in microohms. This resistance will vary
504  *   nominal ballpark figure. This internal resistance is given for the state
506  * @factory_internal_resistance_charging_uohm: the internal resistance of the
508  *   The charging process will affect the internal resistance of the battery
509  *   so this value provides a better resistance under these circumstances.
510  *   This resistance will vary depending on the lifetime and charge of the
541  *   expected internal resistance at this temperature. The resistance is given
543  *   resistance of the battery is usually necessary for calculating the open
546  *   by temperature: highest temperature with lowest resistance first, lowest
547  *   temperature with highest resistance last.
550  *   to internal resistance (Ri). The resistance is given in microohm for the
551  *   corresponding voltage in microvolts. The internal resistance is used to
553  *   of the battery. These voltages to resistance tables apply when the battery
560  *   internal resistance characteristics so a separate table is needed.*
564  * @bti_resistance_ohm: The Battery Type Indicator (BIT) nominal resistance
568  * @bti_resistance_tolerance: The tolerance in percent of the BTI resistance,
570  *   tolerance is 10% we will detect a proper battery if the BTI resistance
676  * with an ideal voltage source (V) in series with an internal resistance (Ri)
691  * If we disconnect the load (here simplified as a fixed resistance Rload)
712  * resistance change, and it will affect the VBAT under load, so correlating
813 					      int resistance);