Lines Matching +full:deep +full:- +full:touch
53 DRM_FORCE_ON_DIGITAL, /* for DVI-I use digital connector */
57 * enum drm_connector_status - status for a &drm_connector
72 * nothing there. It is driver-dependent whether a connector with this
79 * flicker (like load-detection when the connector is in use), or when a
80 * hardware resource isn't available (like when load-detection needs a
90 * enum drm_connector_registration_state - userspace registration status for
123 * - An unregistered connector may only have its DPMS changed from
124 * On->Off. Once DPMS is changed to Off, it may not be switched back
126 * - Modesets are not allowed on unregistered connectors, unless they
130 * - Removing a CRTC from an unregistered connector is OK, but new
161 * struct drm_scdc - Information about scdc capabilities of a HDMI 2.0 sink
182 * struct drm_hdmi_dsc_cap - DSC capabilities of HDMI sink
223 * struct drm_hdmi_info - runtime information about the connected HDMI sink
226 * This information is available in CEA-861-F extension blocks (like HF-VSDB).
235 * defined by the CEA-861-G spec is 219, so the size is 256 bits to map
243 * the CEA-861-G spec is 219, so the size is 256 bits to map up to 256
251 /** @y420_dc_modes: bitmap of deep color support index */
265 * enum drm_link_status - connector's link_status property value
281 * enum drm_panel_orientation - panel_orientation info for &drm_display_info
295 * the panel is mounted upside-down.
302 DRM_MODE_PANEL_ORIENTATION_UNKNOWN = -1,
310 * struct drm_monitor_range_info - Panel's Monitor range in EDID for
327 * struct drm_luminance_range_info - Panel's luminance range for
343 * enum drm_privacy_screen_status - privacy screen status
346 * screen present on some display panels, via the "privacy-screen sw-state"
347 * and "privacy-screen hw-state" properties. Note the _LOCKED enum values
348 * are only valid for the "privacy-screen hw-state" property.
351 * The privacy-screen on the panel is disabled
353 * The privacy-screen on the panel is enabled
355 * The privacy-screen on the panel is disabled and locked (cannot be changed)
357 * The privacy-screen on the panel is enabled and locked (cannot be changed)
399 * enum drm_bus_flags - bus_flags info for &drm_display_info
504 * Set if the Sharp-specific signals (SPL, CLS, PS, REV) must be used
510 * struct drm_display_info - runtime data about the connected sink
513 * fixed display sinks like built-in panels there's not much difference between
547 * @panel_orientation: Read only connector property for built-in panels,
588 * @dvi_dual: Dual-link DVI sink?
612 * @edid_hdmi_rgb444_dc_modes: Mask of supported hdmi deep color modes
618 * @edid_hdmi_ycbcr444_dc_modes: Mask of supported hdmi deep color
649 * @mso_stream_count: eDP Multi-SST Operation (MSO) stream count from
650 * the DisplayID VESA vendor block. 0 for conventional Single-Stream
656 * @mso_pixel_overlap: eDP MSO segment pixel overlap, 0-8 pixels.
666 * struct drm_connector_tv_margins - TV connector related margins
694 * struct drm_tv_connector_state - TV connector related states
718 * struct drm_connector_state - mutable connector state
760 * @commit: Tracks the pending commit to prevent use-after-free conditions.
808 * upscaling, mostly used for built-in panels.
828 * Holds the framebuffer and out-fence for a writeback connector. As
864 * struct drm_connector_funcs - control connectors on a given device
874 * Legacy entry point to set the per-connector DPMS state. Legacy DPMS
964 * received for this output connector->edid must be NULL.
983 * driver-private properties. For atomic drivers it is not used because
1029 * when a connector is being hot-unplugged for drivers that support
1048 * state structure to extend it with driver-private state should use
1081 * Decode a driver-private property value and store the decoded value
1082 * into the passed-in state structure. Since the atomic core decodes all
1087 * Such driver-private properties should really only be implemented for
1096 * driver-private atomic properties.
1103 * possible). Drivers MUST NOT touch any persistent state (hardware or
1113 * 0 if the property has been found, -EINVAL if the property isn't
1128 * Reads out the decoded driver-private property. This is used to
1135 * driver-private atomic properties.
1139 * 0 on success, -EINVAL if the property isn't implemented by the
1163 * This will get called when a hotplug-event for a drm-connector
1171 * Allows connectors to create connector-specific debugfs files.
1177 * struct drm_cmdline_mode - DRM Mode passed through the kernel command-line
1181 * express those parameters and will be filled by the command-line
1195 * Has a mode been read from the command-line?
1292 * drm-connector "panel orientation" property override value,
1304 * struct drm_connector - central DRM connector control structure
1340 * Connector entry in the global connector-list, used by
1360 * the mode_config.list for drivers not supporting hot-add/removing. Can
1432 * when a display is detected. For non hot-pluggable displays such as
1494 /** @privacy_screen_notifier: privacy-screen notifier_block */
1544 /** @helper_private: mid-layer private data */
1569 * Only really meaningful for non-atomic drivers. Atomic drivers should
1576 /** @eld: EDID-like data, if present */
1613 * in Displayport compliance testing - Displayport Link CTS Core 1.2
1652 * dual-link LVDS or dual-link DSI, the driver should try to not expose
1716 return connector->index; in drm_connector_index()
1721 return 1 << connector->index; in drm_connector_mask()
1725 * drm_connector_lookup - lookup connector object
1743 * drm_connector_get - acquire a connector reference
1750 drm_mode_object_get(&connector->base); in drm_connector_get()
1754 * drm_connector_put - release a connector reference
1762 drm_mode_object_put(&connector->base); in drm_connector_put()
1766 * drm_connector_is_unregistered - has the connector been unregistered from
1779 return READ_ONCE(connector->registration_state) == in drm_connector_is_unregistered()
1848 * struct drm_tile_group - Tile group metadata
1852 * @group_data: Sink-private data identifying this group
1872 * struct drm_connector_list_iter - connector_list iterator
1901 * drm_for_each_connector_iter - connector_list iterator macro
1913 * drm_connector_for_each_possible_encoder - iterate connector's possible encoders
1918 drm_for_each_encoder_mask(encoder, (connector)->dev, \
1919 (connector)->possible_encoders)