Lines Matching full:this
23 (half duplex), SSP, SSI, and PSP. This driver framework should
54 Enable this option if you want to enable the SPI memory extension.
55 This extension is meant to simplify interaction with SPI memories
65 This is the driver for the Altera SPI Controller.
78 This is a Device Feature List (DFL) bus driver for the
86 This enables support for the SPI controller present on the
94 This enables support for the SPI controller present on the
101 This enables support for the SPI controller present on the
109 This enables support for the Firmware Memory controller (FMC)
120 This selects a driver for the Atmel SPI Controller, present on
128 This selects a driver for the AT91 USART Controller as SPI Master,
136 This enables support for the Quad SPI controller in master mode.
137 This driver does not support generic SPI. The implementation only
145 If you say yes to this option, support will be included for the
152 This enables support for the Analog Devices AXI SPI Engine SPI controller.
161 This selects a driver for the Broadcom BCM2835 SPI master.
164 "universal SPI master", and the regular SPI controller. This driver
172 This selects a driver for the Broadcom BCM2835 SPI aux master.
176 This driver is for the universal/auxiliary SPI controller.
188 This enables support for the High Speed SPI controller present on
198 Select this option for any one of BRCMSTB, iProc NSP and NS2 SoCs
199 based platforms. This driver works for both SPI master for SPI NOR
206 Select this to get SPI support through I/O pins (GPIO, parallel
208 this code to manage the per-word or per-transfer accesses to the
211 This is library code, and is automatically selected by drivers that
212 need it. You only need to select this explicitly to support driver
213 modules that aren't part of this kernel tree.
220 This uses a custom parallel port cable to connect to an AVR
223 This same cable can be used to flash new firmware.
228 This selects the Cadence SPI controller master driver
238 Flash over 1/2/4-bit wide bus. Enable this option if you have a
250 Flash over upto 8bit wide bus. Enable this option if you have a
258 This enables dedicated general purpose SPI/Microwire1-compatible
265 This enables support for the Coldfire QSPI controller in master
320 in this driver).
328 If you say yes to this option, support will be included for Diolan
331 This driver can also be built as a module. If so, the module
338 This enables using the Cirrus EP93xx SPI controller in master
346 emulation that is designed for serial flash access. This driver
354 This enables support for the driver for FSI bus attached SPI
361 This enables Freescale i.MX LPSPI controllers in master mode.
368 This enables support for the Quad SPI controller in master mode.
371 This controller does not support generic SPI messages. It only
378 This enables support for the driver for GXP bus attached SPI
385 This enables support for HiSilicon SPI controller found on
388 This driver can also be built as a module. If so, the module
396 This enables support for HiSilicon v3xx SPI NOR flash controller
403 This enables support for the Flex SPI controller in master mode.
406 This controller does not support generic SPI messages and only
414 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
416 slaves connected to a bus using this driver are configured as usual,
418 for the chipselect used by this controller driver.
420 Note that this driver often won't achieve even 1 Mbit/sec speeds,
423 speed with a custom version of this driver; see the source code.
429 This enables support for the SPFI master controller found on
436 This enables support for the Freescale i.MX SPI controllers.
442 This enables support for the Ingenic SoCs SPI controller.
444 To compile this driver as a module, choose M here: the module
457 This enables PCI support for the Intel PCH/PCU SPI controller in
458 master mode. This controller is present in modern Intel hardware
460 this driver it is possible to upgrade BIOS directly from Linux.
465 To compile this driver as a module, choose M here: the module
474 This enables platform support for the Intel PCH/PCU SPI
475 controller in master mode. This controller is present in modern
477 settings. Using this driver it is possible to upgrade BIOS
483 To compile this driver as a module, choose M here: the module
490 This enables support for the SPI master controller in the J-Core
498 This driver supports the NS LM70 LLP Evaluation Board,
506 This driver provides an SPI master device to drive Maxim
516 This drivers supports the MPC52xx SPI controller in master SPI
523 This enables using the Freescale MPC52xx Programmable Serial
530 This enables using the Freescale MPC5121 Programmable Serial
547 This enables using the Freescale SPI controllers in master mode.
550 This also enables using the Aeroflex Gaisler GRLIB SPI controller in
558 This enables support for the Freescale DSPI controller in master
565 This enables using the Freescale eSPI controllers in master mode.
567 P20xx, P30xx,P40xx, P50xx uses this controller.
574 This enables master mode support for the SPICC (SPI communication
582 This enables master mode support for the SPIFC (SPI flash
589 This enables the SPI driver for Microchip FPGA SPI controllers.
598 This enables the QSPI driver for Microchip FPGA QSPI controllers.
607 This selects the MediaTek(R) SPI bus driver.
616 This selects a driver for the MediaTek MT7621 SPI Controller.
622 This enables support for SPI NOR controller found on MediaTek
623 ARM SoCs. This is a controller specifically for SPI NOR flash.
633 This enables support for SPI-NAND mode on the MediaTek NAND
634 Flash Interface found on MediaTek ARM SoCs. This controller
643 This enables support for the Flash Interface Unit SPI controller
645 This driver does not support generic SPI. The implementation only
652 This driver provides support for Nuvoton NPCM BMC
659 This driver supports the Lantiq SSC SPI controller in master
660 mode. This controller is found on Intel (former Lantiq) SoCs like
668 This is the driver for OpenCores tiny SPI master controller.
682 This hooks up to the MicroWire controller on OMAP1 chips.
697 This device supports single, dual and quad read support, while
710 This enables using the SPI master controller on the Orion
732 This selects the ARM(R) AMBA(R) PrimeCell PL022 SSP
741 This selects a driver for the PPC4xx SPI Controller.
748 This enables using a PXA2xx or Sodaville SSP port as a SPI master
758 This selects a driver for Rockchip SPI controller.
760 If you say yes to this option, support will be included for
763 The main usecase of this controller is to use spi flash as boot
771 This enables support for Rockchip serial flash controller. This
812 This driver can also be built as a module. If so, the module
819 This driver supports GENI serial engine based SPI controller in
821 yes to this option, support will be included for the built-in SPI
824 This driver can also be built as a module. If so, the module
840 DMA by using the fast-interrupt request framework, This allows
888 This exposes the SPI controller IP from SiFive.
895 This selects the MediaTek(R) SPI slave device driver.
929 This enables support for the Quad SPI controller in master mode.
930 This driver does not support generic SPI. The implementation only
938 this option, support will be included for the SSC driven SPI.
951 This enables using the SPI controller on the Allwinner A31 SoCs.
957 This enables Sunplus SP7021 SPI controller driver on the SP7021 SoCs.
958 This driver can also be built as a module. If so, the module will be
979 This selects the Macronix MX25F0A SPI controller driver.
993 QSPI driver for NVIDIA Tegra QSPI Controller interface. This
1002 SPI driver for NVIDIA Tegra114 SPI Controller interface. This controller
1004 get changed with this controller.
1012 The main usecase of this controller is to use spi flash as boot
1036 This driver also supports the ML7213/ML7223/ML7831, a companion chip
1044 This enables a driver for the Socionext UniPhier SoC SCSSI SPI controller.
1049 This driver supports SCSSI only.
1065 This exposes the SPI controller IP from the Xilinx EDK.
1089 This simple SPI master controller is built into xtfpga bitstreams
1098 This enables support for the Zynq Quad SPI controller
1100 This controller only supports SPI memory interface.
1115 # Add new SPI master controllers in alphabetical order above this line
1124 This adds support for SPI multiplexers. Each SPI mux will be
1126 to be chip selects on this controller. It is still necessary to
1138 This supports user mode SPI protocol drivers.
1140 Note that this application programming interface is EXPERIMENTAL
1147 This enables the SPI loopback testing framework driver
1157 such as the TLE6220, TLE6230 and TLE6240. This provides a
1162 # Add new SPI protocol masters in alphabetical order above this line