160 	/* Hold OOB state machine in reset */  in sci_phy_link_layer_initialization()
538 		/* Release the spinup hold state and reset the OOB state machine */  in sci_phy_consume_power_handler()
547 		/* Now restart the OOB operation */  in sci_phy_consume_power_handler()
700 		       /* Start the oob/sn state machine over again */  in sci_phy_event_handler()
733 			 * continue OOB/SN as if this were a SATA PHY */  in sci_phy_event_handler()
747 		       /* Start the oob/sn state machine over again */  in sci_phy_event_handler()
763 			 * SATA PHY event continue OOB/SN as if this were a  in sci_phy_event_handler()
772 			/* Start the oob/sn state machine over again */  in sci_phy_event_handler()
779 			/* Start the oob/sn state machine over again */  in sci_phy_event_handler()
817 			/* There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
849 			/* There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
890 			 * There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
1201 	/** Reset OOB sequence - start */  in scu_link_layer_start_oob()
1208 	/** Reset OOB sequence - end */  in scu_link_layer_start_oob()
1210 	/** Start OOB sequence - start */  in scu_link_layer_start_oob()
1215 	/** Start OOB sequence - end */  in scu_link_layer_start_oob()
1223  * hardware requires that we reset the OOB state machine and set the hard reset
1224  * bit in the phy configuration register. We then must start OOB over with the
1244 	/* Now take the OOB state machine out of reset */  in scu_link_layer_tx_hard_reset()