Lines Matching full:command

42 	This command will trigger a scan.
43 	The command will then display the scan table entries
46 	The above command can be used to connect to an AP with a particular SSID.
48 	WEP encryption, wep keys can be specified in the command.
49 …Note: Every time before connecting to an AP scan command (iw dev mlan0 scan) should be used by use…
52 	This command will be used to disconnect from an AP.
56 	The command will be used to join or create an ibss. Optionally, operating frequency,
61 	The command will be used to leave an ibss network.
64 	The command will be used to get the connection status. The command will return parameters
84 	The command will be used to change the regulatory domain.
87 	The command will be used to get current regulatory domain.
90 	This command is used to get driver info.
135 	is_cmd_timedout = <0/1 command timeout not occurred/occurred>
136 	timeout_cmd_id = <command id of the last timeout command>
137 	timeout_cmd_act = <command action of the last timeout command>
138 	last_cmd_id = <command id of the last several commands sent to device>
139 	last_cmd_act = <command action of the last several commands sent to device>
140 	last_cmd_index = <0 based last command index>
141 	last_cmd_resp_id = <command id of the last several command responses received from device>
142 	last_cmd_resp_index = <0 based last command response index>
154 	cmd_sent = <0/1, send command resources available/sending command to device>
168 	This command is used to read/write the adapter register.
186 	This command is used to read/write the firmware memory.
208 	This command is used to read the EEPROM contents of the card.
222 	This command is used to debug/simulate host sleep feature using
252         This command is used to get the statistics available in the station.
258 	This command is used to dump driver information and firmware memory
265 	This command is used to get extended firmware version string using