Lines Matching full:indicates
53 * Indicates the first MSDU of the PPDU. If both first_mpdu
61 * Indicates the last MSDU of the last MPDU of the PPDU. The
71 * Indicates no matching entries within the max search
75 * Indicates an unsuccessful search for the peer index due to
87 * Set if frame type indicates either null data or QoS null
111 * Indicates that this is an 802.11 fragment frame. This is
121 * Indicates that this status has a corresponding MSDU that
134 * Indicates that the MSDU length from the 802.3 encapsulated
138 * Indicates that the computed checksum (tcp_udp_chksum) did
142 * Indicates that the computed checksum did not match the
146 * Indicates no matching entry was found in the address search
150 * Indicates no matching entry was found in the address search
154 * Indicates an unsuccessful search for the source MAC address
158 * Indicates an unsuccessful search for the destination MAC
162 * Indicates that this data type frame is not encrypted even if
173 * Indicates that at least one of the rx buffers has been
178 * Indicates that the MPDU was pre-maturely terminated
183 * Indicates that the MPDU Michael integrity check failed
186 * Indicates that the MPDU decrypt integrity check failed
189 * Indicates that the MPDU FCS check failed
192 * If set indicates that the RX packet data, RX header data, RX
226 * Indicates the number of more buffers associated with RX DMA
230 * Indicates the number of more buffers associated with RX DMA
234 * Indicates the number of more buffers associated with RX DMA
238 * Indicates the number of more buffers associated with RX DMA
316 * Indicates type of decrypt cipher used (as defined in the
389 * Indicates that this is the last MPDU of a PPDU.
392 * Indicates that a delimiter FCS error occurred after this
509 * Indicates the IP offset in bytes from the start of the
514 * Indicates the destination RX rings for this MSDU.
517 * Indicates the offset in bytes to the start of TCP or UDP
520 * indicates that the offset is longer than 127 bytes.
538 * Indicates the MSDU number within a MPDU. This value is
543 * Indicates the format after decapsulation:
550 * Set if L2 layer indicates IPv4 protocol.
553 * Set if L2 layer indicates IPv6 protocol.
557 * protocol indicates TCP.
561 * protocol indicates UDP.
564 * Indicates that either the IP More frag bit is set or IP frag
565 * number is non-zero. If set indicates that this is a
661 * Indicates the number classification filter rule
686 * Indicates the first MSDU of A-MSDU. If both first_msdu and
692 * Indicates the last MSDU of the A-MSDU. MPDU end status is
696 * Indicates that the MSDU threshold was exceeded and thus
705 * Indicates that the first delimiter had a FCS failure. Only
767 * Value of 0x80 indicates invalid.
771 * Value of 0x80 indicates invalid.
775 * Value of 0x80 indicates invalid.
779 * Value of 0x80 indicates invalid.
783 * Value of 0x80 indicates invalid.
787 * Value of 0x80 indicates invalid.
791 * Value of 0x80 indicates invalid.
795 * Value of 0x80 indicates invalid.
799 * Value of 0x80 indicates invalid.
803 * Value of 0x80 indicates invalid.
807 * Value of 0x80 indicates invalid.
811 * Value of 0x80 indicates invalid.
815 * Value of 0x80 indicates invalid.
819 * Value of 0x80 indicates invalid.
823 * Value of 0x80 indicates invalid.
827 * Value of 0x80 indicates invalid.
831 * bandwidths. Value of 0x80 indicates invalid.
862 * Legacy signal rate select. If set then l_sig_rate indicates
863 * CCK rates. If clear then l_sig_rate indicates OFDM rates.
875 * Indicates the type of preamble ahead:
904 * Indicates that the packet data carries H information which
1253 * Indicates a PHY error was detected for this PPDU.
1256 * Indicates that location information was requested.
1259 * Indicates that the packet data carries H information which
1269 * Indicates that a HT or VHT Ack/BA frame was transmitted in
1273 * Indicates that the BB has captured a channel dump. FW can
1283 * Indicates the number of bytes of baseband information for
1285 * which indicates that this is not a normal PPDU but rather