Lines Matching full:sgmii
63 /* SGMII */
392 /* No need to trigger re-ANEG if link speed is 2.5G or SGMII ANEG is in gpy_config_aneg()
399 /* There is a design constraint in GPY2xx device where SGMII AN is in gpy_config_aneg()
402 * again, SGMII AN is not triggered and hence no new in-band message in gpy_config_aneg()
403 * from GPY to MAC side SGMII. in gpy_config_aneg()
405 * MAC. At this condition, once MAC side SGMII is up, MAC side SGMII in gpy_config_aneg()
411 * retriggerring SGMII AN. in gpy_config_aneg()
413 * reboot), polling of TPI link status is not needed and SGMII AN is in gpy_config_aneg()
416 * retriggering SGMII AN. Note: in case of speed change, GPY FW will in gpy_config_aneg()
417 * initiate SGMII AN. in gpy_config_aneg()
430 /* Trigger SGMII AN. */ in gpy_config_aneg()
444 /* Automatically switch SERDES interface between SGMII and 2500-BaseX in gpy_update_interface()
454 "Error: Disable of SGMII ANEG failed: %d\n", in gpy_update_interface()
463 /* Enable and restart SGMII ANEG for 10/100/1000Mbps link speed in gpy_update_interface()
471 "Error: Enable of SGMII ANEG failed: %d\n", in gpy_update_interface()