616 		e_err("ME firmware caused invalid RDT - resetting\n");  in e1000e_update_rdt_wa()
633 		e_err("ME firmware caused invalid TDT - resetting\n");  in e1000e_update_tdt_wa()
1135 	e_err("Detected Hardware Unit Hang:\n"  in e1000_print_hw_hang()
1159 		e_err("Try turning off Tx pause (flow control) via ethtool\n");  in e1000_print_hw_hang()
1640 			e_err("pskb_may_pull failed.\n");  in e1000_clean_jumbo_rx_irq()
2081 			e_err("Failed to initialize MSI-X interrupts.  Falling back to MSI interrupts.\n");  in e1000e_set_interrupt_capability()
2091 			e_err("Failed to initialize MSI interrupts.  Falling back to legacy interrupts.\n");  in e1000e_set_interrupt_capability()
2192 		e_err("Unable to allocate interrupt, Error: %d\n", err);  in e1000_request_irq()
2360 	e_err("Unable to allocate memory for the transmit descriptor ring\n");  in e1000e_setup_tx_resources()
2413 	e_err("Unable to allocate memory for the receive descriptor ring\n");  in e1000e_setup_rx_resources()
2657 	e_err("Unable to allocate memory for queues\n");  in e1000_alloc_queues()
3710 		e_err("Timesync Tx Control register not set as expected\n");  in e1000e_config_hwtstamp()
3723 		e_err("Timesync Rx Control register not set as expected\n");  in e1000e_config_hwtstamp()
4128 		e_err("Hardware Error\n");  in e1000e_reset()
4677 			e_err("Interrupt allocation failed\n");  in e1000e_open()
5858 				e_err("__pskb_pull_tail failed.\n");  in e1000_xmit_frame()
5988 		e_err("Reset adapter unexpectedly\n");  in e1000_reset_task()
6055 		e_err("Jumbo Frames not supported.\n");  in e1000_change_mtu()
6063 		e_err("Jumbo Frames not supported on this device when CRC stripping is disabled.\n");  in e1000_change_mtu()
6254 		e_err("Could not acquire PHY\n");  in e1000_init_phy_wakeup()
6309 		e_err("Could not set PHY Host Wakeup bit\n");  in e1000_init_phy_wakeup()