Lines Matching +full:nomadik +full:- +full:i2c
1 # SPDX-License-Identifier: GPL-2.0-only
44 tristate "Active-semi ACT8945A"
47 depends on I2C && OF
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
76 depends on I2C=y
85 depends on I2C=y && OF
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
94 depends on I2C=y
98 the I2C driver and the core APIs _only_, you have to select
105 depends on I2C=y
119 over at91-usart-serial driver and usart-spi-driver. Only one function
129 which embeds a SPI controller, a I2C controller and a USART. Only
135 tristate "Atmel HLCDC (High-end LCD Controller)"
153 depends on I2C
162 depends on I2C
172 tristate "X-Powers AC100"
176 If you say Y here you get support for the X-Powers AC100 audio codec
187 tristate "X-Powers AXP series PMICs with I2C"
190 depends on I2C
192 If you say Y here you get support for the X-Powers AXP series power
193 management ICs (PMICs) controlled with I2C.
200 soon as possible. For the same reason the I2C bus driver options
204 tristate "X-Powers AXP series PMICs with RSB"
208 If you say Y here you get support for the X-Powers AXP series power
221 sub-devices. This driver will instantiate additional drivers such
225 called cros-ec-dev.
239 tristate "Cirrus Logic Madera codecs with I2C"
241 depends on I2C
245 core functionality controlled via I2C.
302 depends on I2C=y
306 usually found on PXA processors-based platforms. This includes
307 the I2C driver and the core APIs _only_, you have to select
309 LEDs and battery-charger under the corresponding menus.
328 bool "Dialog Semiconductor DA9052/53 PMIC variants with I2C"
332 depends on I2C=y
335 when controlled using I2C. This driver provides common support
344 depends on I2C=y
348 accessing the device as well as the I2C interface to the chip itself.
360 depends on I2C
364 This includes the I2C driver and core APIs.
373 depends on I2C
376 This includes the I2C driver and core APIs.
381 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
382 depends on I2C
387 This adds support for the DA9150 integrated charger and fuel-gauge
397 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
398 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
404 depends on I2C
408 This adds support for the power-off functionality and access to
426 depends on (I2C && OF)
433 such as push-button monitor, multiple ADC's for voltage and
441 depends on (SPI_MASTER || I2C)
459 tristate "Freescale MC13892 I2C interface"
460 depends on I2C
464 Select this if your MC13xxx is connected via an I2C bus.
468 depends on I2C
483 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
487 mxs-lradc-adc for ADC readings
488 mxs-lradc-ts for touchscreen support
491 called mxs-lradc.
508 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
513 We communicate with the Hi6421 via memory-mapped I/O.
523 multi-functions, such as regulators, RTC, codec, Coulomb counter,
548 handled by the leds-pasic3 and ds1wm drivers.
551 bool "HTC I2C PLD chip support"
552 depends on I2C=y && GPIOLIB
556 This device provides input and output GPIOs through an I2C
557 interface to one or more sub-chips.
560 tristate "Intel Quark MFD I2C GPIO"
566 This MFD provides support for I2C and GPIO that exist only
569 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
592 depends on HAS_IOMEM && I2C=y && GPIOLIB && COMMON_CLK
606 causes the designware-i2c driver to be builtin for the same reason.
621 depends on ACPI && HAS_IOMEM && I2C=y && COMMON_CLK
633 causes the designware-i2c driver to be builtin for the same reason.
638 depends on I2C=y && I2C_DESIGNWARE_PLATFORM=y
650 needs the designware-i2c driver to be builtin for the same reason.
674 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
683 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
696 multi-function device that exposes IPC, General Control
697 Register and P-unit access. In addition this creates devices
712 depends on I2C
717 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
718 options must be selected to enable device-specific functions.
724 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
728 This is the core driver for the Janz CMOD-IO PCI MODULbus
740 functions like watchdog, GPIO, UART and I2C bus.
743 will be called kempld-core.
747 depends on I2C
753 This includes the I2C driver and the core APIs _only_, you have to
755 battery-charger under the corresponding menus.
759 depends on I2C
765 the I2C driver and the core APIs _only_, you have to select individual
771 depends on I2C=y
776 This includes the I2C driver and the core APIs _only_, you have to
778 battery-charger under the corresponding menus.
782 depends on I2C
789 MAX77836 Micro-USB ICs with battery charger.
796 depends on I2C=y
811 depends on I2C
826 depends on I2C
841 depends on I2C
855 depends on I2C
862 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
869 depends on I2C=y
884 depends on I2C
895 depends on I2C=y
905 depends on I2C=y
918 depends on I2C=y
934 depends on I2C
938 PMIC part includes 2-channel BUCKs and 2-channel LDOs
939 LDO part includes 4-channel LDOs
946 depends on I2C
951 voltage supply, one general purpose LDO, and the USB Type-C & PD
952 controller complies with the latest USB Type-C and PD standards.
969 depends on I2C
973 which is a Board Management Controller connected to the I2C bus.
974 The device supports multiple sub-devices like LED, HWMON and WDT.
993 through different interfaces, including SPI, I2C, and PCIe.
999 called ocelot-soc.
1030 There are mfd cell drivers available for i2c master, adc and
1039 depends on I2C
1044 certain e-book readers designed by the original design manufacturer
1048 tristate "Nokia Retu and Tahvo multi-function device"
1050 depends on I2C
1053 Retu and Tahvo are a multi-function devices found on Nokia
1058 depends on I2C
1064 so that function-specific drivers can bind to them.
1099 built-in PM8xxx PMIC chips.
1105 module. This will build a module called "pm8xxx-core".
1134 series as a module. The module will be called "qcom-spmi-pmic".
1138 depends on I2C
1143 To enable support for building sub-devices as modules,
1147 tristate "RDC R-321x southbridge"
1151 Say yes here if you want to have support for the RDC R-321x SoC
1157 depends on I2C
1167 depends on I2C
1173 which includes the I2C driver and the Core APIs. This driver provides
1175 sub-devices like charger, fuel gauge, flash LED, current source,
1180 depends on I2C
1192 depends on I2C=y
1199 through i2c interface. The device supports multiple sub-devices
1206 depends on I2C && OF
1214 through I2C interface. The device supports multiple sub-devices
1219 depends on I2C
1233 depends on I2C=y
1246 module will be called sec-core.
1253 depends on I2C
1258 radio. This MFD driver connects the radio-si476x V4L2 module
1262 module will be called si476x-core.
1266 depends on I2C
1271 to be shared by all sub-devices.
1274 sub-devices represented by child nodes in Device Tree will be
1279 depends on I2C
1287 * SMARC-sAL28
1312 depends on I2C
1337 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1348 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1356 since hardware version v1.0) or the I2C bus via PRCMU. It also adds
1361 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1372 depends on (I2C=y || SPI_MASTER=y)
1391 GPIO: stmpe-gpio
1392 Keypad: stmpe-keypad
1393 Touchscreen: stmpe-ts
1394 ADC: stmpe-adc
1400 bool "STMicroelectronics STMPE I2C Interface"
1401 depends on I2C=y
1404 This is used to enable I2C interface of STMPE
1453 depends on I2C=y && MACH_DAVINCI_DM355_EVM
1461 depends on I2C
1472 depends on I2C=y
1482 depends on I2C
1506 depends on I2C=y
1513 depends on I2C
1520 high-power "white LED driver". This boost converter is
1526 depends on I2C && GPIOLIB
1540 depends on I2C
1555 depends on I2C
1568 depends on I2C=y
1581 depends on I2C && OF
1597 depends on I2C
1611 depends on I2C && OF
1625 depends on I2C && OF
1640 depends on I2C=y
1655 depends on I2C=y
1672 tristate "TI TPS65912 Power Management chip with I2C"
1675 depends on I2C
1678 PM chips with I2C interface.
1691 depends on I2C=y
1698 so that function-specific drivers can bind to them.
1700 These multi-function chips are found on many OMAP2 and OMAP3
1714 This driver uses board-specific data to initialize the resources
1726 depends on I2C=y
1740 depends on I2C=y && ARCH_OMAP2
1744 regulators, Dual slot memory card transceivers, real-time clock
1750 depends on I2C
1755 driver connects the radio-wl1273 V4L2 module and the wl1273
1760 depends on I2C
1769 backlight or ambient-light-sensor functionality of the device.
1780 for in-vehicle infontainment, called Russellville.
1784 depends on I2C=y
1824 tristate "TQ-Systems IO controller TQMX86"
1828 TQ-Systems IO controller and watchdog device, found on their
1844 depends on I2C=y && OF
1855 tristate "Cirrus Logic/Wolfson Microelectronics Arizona platform with I2C"
1858 depends on I2C
1861 audio SoC core functionality controlled via I2C.
1906 depends on I2C=y
1918 bool "Wolfson Microelectronics WM831x/2x PMICs with I2C"
1923 depends on I2C=y
1926 when controlled using I2C. This driver provides common support
1947 bool "Wolfson Microelectronics WM8350 with I2C"
1950 depends on I2C=y
1955 I2C as the control interface. Additional options must be
1963 depends on I2C
1965 The WM8994 is a highly integrated hi-fi CODEC designed for
1979 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
1988 depends on I2C && (ARCH_NOMADIK || COMPILE_TEST)
1993 in various ST Microelectronics and ST-Ericsson embedded
1994 Nomadik series.
1998 depends on I2C=y
2011 depends on I2C=y
2018 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2019 management ICs mainly for battery-powered portable devices.
2022 also a single-cell linear charger, a Coulomb counter, a real-time
2027 depends on I2C=y
2034 designed to be used to power R-Car series processors.
2037 tristate "Support for STM32 Low-Power Timer"
2043 Select this option to enable STM32 Low-Power Timer driver
2048 module will be called stm32-lptimer.
2063 depends on (I2C=y && OF)
2078 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2079 depends on I2C
2084 Support for the STMicroelectronics Multi-Function eXpander.
2109 tristate "Actions Semi ATC260x PMICs with I2C"
2112 depends on I2C
2114 Support for the Actions Semi ATC260x PMICs controlled via I2C.
2122 depends on I2C
2134 power-on options, power-off control and system FAN control on recent
2143 depends on I2C
2154 depends on I2C && OF
2214 This option enables basic support for the SGI IOC3-based
2236 tristate "Renesas Synchronization Management Unit with I2C"
2237 depends on I2C && OF
2242 Clockmatrix and 82P33XXX series. This option supports I2C as