Lines Matching +full:db8500 +full:- +full:prcmu +full:- +full:regulators
1 # SPDX-License-Identifier: GPL-2.0-only
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
51 linear regulators, along with a complete ActivePath battery
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
135 tristate "Atmel HLCDC (High-end LCD Controller)"
172 tristate "X-Powers AC100"
176 If you say Y here you get support for the X-Powers AC100 audio codec
187 tristate "X-Powers AXP series PMICs with I2C"
192 If you say Y here you get support for the X-Powers AXP series power
195 components like regulators or the PEK (Power Enable Key) under the
204 tristate "X-Powers AXP series PMICs with RSB"
208 If you say Y here you get support for the X-Powers AXP series power
211 components like regulators or the PEK (Power Enable Key) under the
221 sub-devices. This driver will instantiate additional drivers such
225 called cros-ec-dev.
306 usually found on PXA processors-based platforms. This includes
308 individual components like LCD backlight, voltage regulators,
309 LEDs and battery-charger under the corresponding menus.
381 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
387 This adds support for the DA9150 integrated charger and fuel-gauge
397 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
398 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
408 This adds support for the power-off functionality and access to
433 such as push-button monitor, multiple ADC's for voltage and
483 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
487 mxs-lradc-adc for ADC readings
488 mxs-lradc-ts for touchscreen support
491 called mxs-lradc.
508 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
509 functions, such as regulators, RTC, codec, Coulomb counter, etc.
511 individual components like voltage regulators under corresponding
513 We communicate with the Hi6421 via memory-mapped I/O.
523 multi-functions, such as regulators, RTC, codec, Coulomb counter,
527 individual components like voltage regulators under corresponding
548 handled by the leds-pasic3 and ds1wm drivers.
557 interface to one or more sub-chips.
569 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
606 causes the designware-i2c driver to be builtin for the same reason.
633 causes the designware-i2c driver to be builtin for the same reason.
650 needs the designware-i2c driver to be builtin for the same reason.
674 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
683 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
696 multi-function device that exposes IPC, General Control
697 Register and P-unit access. In addition this creates devices
717 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
718 options must be selected to enable device-specific functions.
724 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
728 This is the core driver for the Janz CMOD-IO PCI MODULbus
743 will be called kempld-core.
754 select individual components like voltage regulators, RTC and
755 battery-charger under the corresponding menus.
777 select individual components like voltage regulators, RTC and
778 battery-charger under the corresponding menus.
789 MAX77836 Micro-USB ICs with battery charger.
805 RTC, regulators, clock generator, watchdog etc. This driver
861 This is a Power Management IC with 4 buck regulators, 9
862 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
938 PMIC part includes 2-channel BUCKs and 2-channel LDOs
939 LDO part includes 4-channel LDOs
951 voltage supply, one general purpose LDO, and the USB Type-C & PD
952 controller complies with the latest USB Type-C and PD standards.
974 The device supports multiple sub-devices like LED, HWMON and WDT.
999 called ocelot-soc.
1044 certain e-book readers designed by the original design manufacturer
1048 tristate "Nokia Retu and Tahvo multi-function device"
1053 Retu and Tahvo are a multi-function devices found on Nokia
1064 so that function-specific drivers can bind to them.
1099 built-in PM8xxx PMIC chips.
1102 such as: MPPs, GPIOs, regulators, interrupts, and PWM.
1105 module. This will build a module called "pm8xxx-core".
1115 This is required to access many regulators, clocks and bus
1134 series as a module. The module will be called "qcom-spmi-pmic".
1143 To enable support for building sub-devices as modules,
1147 tristate "RDC R-321x southbridge"
1151 Say yes here if you want to have support for the RDC R-321x SoC
1175 sub-devices like charger, fuel gauge, flash LED, current source,
1199 through i2c interface. The device supports multiple sub-devices
1200 like GPIO, interrupts, RTC, LDO and DCDC regulators, onkey.
1214 through I2C interface. The device supports multiple sub-devices
1215 including interrupts, RTC, LDO & DCDC regulators, and onkey.
1246 module will be called sec-core.
1247 Have in mind that important core drivers (like regulators) depend
1258 radio. This MFD driver connects the radio-si476x V4L2 module
1262 module will be called si476x-core.
1271 to be shared by all sub-devices.
1274 sub-devices represented by child nodes in Device Tree will be
1287 * SMARC-sAL28
1337 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1348 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1356 since hardware version v1.0) or the I2C bus via PRCMU. It also adds
1361 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1365 Select this option to enable support for the DB8500 Power Reset
1391 GPIO: stmpe-gpio
1392 Keypad: stmpe-keypad
1393 Touchscreen: stmpe-ts
1394 ADC: stmpe-adc
1477 TI LP8788 PMU supports regulators, battery charger, RTC,
1520 high-power "white LED driver". This boost converter is
1530 Power Management chips. These include voltage regulators,
1544 regulators, lithium ion/polymer battery charging, touch screen
1588 These include voltage regulators, lithium ion/polymer battery
1603 These include voltage regulators, thermal protection, configurable
1617 These include voltage regulators, thermal protection, configurable
1632 These include voltage regulators, gpio and other features
1698 so that function-specific drivers can bind to them.
1700 These multi-function chips are found on many OMAP2 and OMAP3
1710 TWL4030 family chips. Most of these resources are regulators,
1714 This driver uses board-specific data to initialize the resources
1744 regulators, Dual slot memory card transceivers, real-time clock
1755 driver connects the radio-wl1273 V4L2 module and the wl1273
1769 backlight or ambient-light-sensor functionality of the device.
1780 for in-vehicle infontainment, called Russellville.
1824 tristate "TQ-Systems IO controller TQMX86"
1828 TQ-Systems IO controller and watchdog device, found on their
1965 The WM8994 is a highly integrated hi-fi CODEC designed for
1979 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
1993 in various ST Microelectronics and ST-Ericsson embedded
2018 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2019 management ICs mainly for battery-powered portable devices.
2022 also a single-cell linear charger, a Coulomb counter, a real-time
2034 designed to be used to power R-Car series processors.
2037 tristate "Support for STM32 Low-Power Timer"
2043 Select this option to enable STM32 Low-Power Timer driver
2048 module will be called stm32-lptimer.
2078 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2084 Support for the STMicroelectronics Multi-Function eXpander.
2134 power-on options, power-off control and system FAN control on recent
2214 This option enables basic support for the SGI IOC3-based