Lines Matching full:decoder

3  * ImgTec IR Hardware Decoder found in PowerDown Controller.
25  * struct img_ir_control - Decoder control settings
26  * @decoden:	Primary decoder enable
30  * @decodinpol:	Decoder input polarity (1=active high)
32  * @d1validsel:	Decoder 2 takes over if it detects valid data
34  * @decodend2:	Secondary decoder enable (no leader symbol)
36  * @bitinvd2:	Secondary decoder bit inversion switch (1=don't invert)
90  * @s00:	Zero symbol timing data for primary decoder
91  * @s01:	One symbol timing data for primary decoder
92  * @s10:	Zero symbol timing data for secondary (no leader symbol) decoder
93  * @s11:	One symbol timing data for secondary (no leader symbol) decoder
118  * @s00:	Zero symbol timing register value for primary decoder
119  * @s01:	One symbol timing register value for primary decoder
120  * @s10:	Zero symbol timing register value for secondary decoder
121  * @s11:	One symbol timing register value for secondary decoder
146  * struct img_ir_decoder - Decoder settings for an IR protocol.
190  * struct img_ir_reg_timings - Reg values for decoder timings at clock rate.
214  * struct img_ir_priv_hw - Private driver data for hardware decoder.
220  * @decoder:		Current decoder settings.
223  * @reg_timings:	Timing reg values for decoder at clock rate.
227  * @stopping:		Indicates that decoder is being taken down and timers
238 	const struct img_ir_decoder	*decoder;  member