Lines Matching +full:flash +full:- +full:leds
1 # SPDX-License-Identifier: GPL-2.0-only
13 LEDs from both userspace and optionally, by kernel events (triggers).
20 This option enables the LED sysfs class in /sys/class/leds. You'll
21 need this to do anything useful with LEDs. If unsure, say Y.
24 tristate "LED Flash Class Support"
27 This option enables the flash LED sysfs class in /sys/class/leds.
28 It wraps LED Class and adds flash LEDs specific sysfs attributes
30 for the flash related features of a LED device. It can be built
37 This option enables the multicolor LED sysfs class in /sys/class/leds.
40 for multicolor LEDs that are grouped together. This class is not
41 intended for single color LEDs. It can be built as a module.
48 for LED sysfs class devices under /sys/class/leds.
50 See Documentation/ABI/testing/sysfs-class-led for details.
59 This option enables support for on-chip LED drivers found on Marvell
66 This option enables support for the AN30259A 3-channel
70 will be called leds-an30259a.
77 This driver makes the PC Engines APU1 front panel LEDs
80 If you're looking for APU2/3, use the pcengines-apu2 driver.
84 module will be called leds-apu.
92 LEDs on Dell Wyse 3020 (Ariel) board via the KB3930 Embedded
101 This option enables support for the AW2013 3-channel
105 will be called leds-aw2013.
113 This option enables support for LEDs connected to the BCM6328
122 This option enables support for LEDs connected to the BCM6358
131 This option enables support for LEDs offered by Motorola's
145 will be called leds-cr0014114.
158 will be called leds-el15203000.
167 This option enables basic support for the LEDs found on the front
168 side of CZ.NIC's Turris Omnia router. There are 12 RGB LEDs on the
197 This option enables support for the LEDs on National Semiconductor /
200 The LEDs can be controlled directly, through PWM input, or by the
201 ambient-light-sensor interface. The chip supports
202 hardware-accelerated blinking with maximum on and off periods of 9.8
210 This option enables support for LEDs connected to LM3642.
211 The LM3642 is a 4MHz fixed-frequency synchronous boost
212 converter plus 1.5A constant current driver for a high-current
228 This option enables support for the LEDs on Sharp Locomo.
229 Zaurus models SL-5500 and SL-5600.
244 This option enables support for on-chip LED drivers found on
248 tristate "LED Support for Samsung S3C24XX GPIO LEDs"
252 This option enables support for LEDs connected to GPIO lines
264 tristate "LED Support for the WRAP series LEDs"
268 This option enables support for the PCEngines WRAP programmable LEDs.
282 This option enables support for the Cobalt Raq series LEDs.
291 LEDs on the I/O and CPU boards of SunFire UltraSPARC servers.
329 tristate "LED Support for GPIO connected LEDs"
333 This option enables support for the LEDs connected to GPIO
334 outputs. To be useful the particular board must have LEDs
335 and they must be connected to the GPIO lines. The LEDs must be
344 This option enables support for LEDs connected to the National
349 module will be called leds-lp3944.
358 This option enables support for LEDs connected to the Texas
362 module will be called leds-lp3952.
373 module will be called leds-lp50xx.
435 This option enables support for the Keyboard LEDs on the LP8788 PMIC.
444 This option enables support for the display cluster LEDs
454 programs through the LEDs subsystem. This LED has three
457 The driver supports two kinds of interface: using ledtrig-timer
458 or through /sys/class/leds/clevo::mail/brightness. As this LED
477 module will be called leds-clevo-mail.
484 This option enables support for LEDs connected to PCA955x
504 This option enables support for LEDs connected to the PCA963x
509 tristate "LED support for status LEDs on WM831x PMICs"
513 This option enables support for the status LEDs of the WM831x
521 This option enables support for LEDs driven by the Wolfson
529 This option enables support for on-chip LED drivers found
533 tristate "Dialog DA9052/DA9053 LEDS"
537 This option enables support for on-chip LED drivers found
538 on Dialog Semiconductor DA9052-BC and DA9053-AA/Bx PMICs.
546 which can be used to control up to four LEDs.
553 This option enables support for pwm driven LEDs
560 This option enables support for regulator driven LEDs.
578 drive or power LEDs on the front panel. Using this driver
586 This option enables support for LEDs driven by a Linear Technology
587 LT3593 controller. This controller uses a special one-wire pulse
595 This option enables support for on-chip LED drivers found
599 be called leds-adp5520.
606 This option enables support for on-chip LED drivers found
610 tristate "LED support for Network Space v2 GPIO LEDs"
615 This option enables support for the dual-GPIO LEDs found on the
621 n090401 (Seagate NAS 4-Bay)
624 tristate "LED support for Big Network series LEDs"
630 This option enables support for LEDs found on the LaCie 2Big
631 and 5Big Network v2 boards. The LEDs are wired to a CPLD and are
640 This option enables support for the LEDs on the HTC ASIC3. The HTC
641 ASIC3 LED GPIOs are inputs, not outputs, thus the leds-gpio driver
643 period from 62ms to 125s. Say Y to enable LEDs on the HP iPAQ hx4700.
649 This option enables support for LEDs connected to TC6507
651 Driver support brightness control and hardware-assisted blinking.
665 LEDs driver for MAX77650 family of PMICs from Maxim Integrated.
671 This option enables support for on-chip LED drivers on
679 This option enables support for LEDs connected to LM3554
680 and LM3556. It includes Torch, Flash and Indicator functions.
686 This option enables support for the LEDs on the Bachmann OT200.
687 Say Y to enable LEDs on the Bachmann OT200.
693 Say Y here to include support for the MEN 14F021P00 BMC LEDs.
696 will be called leds-menf21bmc.
703 This option enables support for LEDs connected to ISSI IS31FL319x
708 called leds-is31fl319x.
714 Say Y here to include support for ISSI IS31FL32XX and Si-En SN32xx
715 LED controllers. They are I2C devices with multiple constant-current
716 channels, each with independent 256-level PWM control.
724 LEDs.
727 called leds-sc27xx-bltc.
745 This option enables support for the system LEDs present on
748 will be called leds-powernv.
751 bool "LED support for LEDs on system controllers"
756 This option enables support for the LEDs on syscon type
773 This option enables support for the LEDs on the Mellanox
780 This option enables support for the LEDs on the Mellanox Ethernet and
783 module, choose 'M' here: the module will be called leds-mlxreg.
789 This option enables support for userspace LEDs. Say 'y' to enable this
798 This option enables support for the User1 and User2 LEDs on NI
802 will be called leds-nic78bx.
846 It is a single boost converter primarily for white LEDs and
854 This option enables support for the Red and White LEDs of
858 will be called leds-ip30.
867 source "drivers/leds/blink/Kconfig"
869 comment "Flash and Torch LED drivers"
870 source "drivers/leds/flash/Kconfig"
873 source "drivers/leds/rgb/Kconfig"
876 source "drivers/leds/trigger/Kconfig"
879 source "drivers/leds/simple/Kconfig"