Lines Matching +full:simple +full:- +full:framebuffer

1 // SPDX-License-Identifier: BSD-3-Clause
16 	 * Yes, you are correct, there is NO MORE {msm,board,pmic}-id on SM8350!
22 	chassis-type = "handset";
25 		#address-cells = <2>;
26 		#size-cells = <2>;
29 		framebuffer: framebuffer@e1000000 {  label
30 			compatible = "simple-framebuffer";
33 			/* The display, even though it's 4K, initializes at 1080-ish p */
47 	gpio-keys {
48 		compatible = "gpio-keys";
52 		key-vol-down {
56 			debounce-interval = <15>;
57 			linux,can-disable;
58 			gpio-key,wakeup;
62 	reserved-memory {
65 			no-map;
71 			console-size = <0x40000>;
72 			record-size = <0x1000>;
73 			no-map;
80 	firmware-name = "qcom/adsp.mbn";
85 	firmware-name = "qcom/cdsp.mbn";
90 	clock-frequency = <1000000>;
97 	clock-frequency = <400000>;
104 	clock-frequency = <400000>;
111 	clock-frequency = <1000000>;
116 		interrupt-parent = <&tlmm>;
118 		reset-gpios = <&tlmm 37 GPIO_ACTIVE_HIGH>;
119 		cirrus,boost-peak-milliamp = <4000>;
120 		cirrus,boost-ind-nanohenry = <1000>;
121 		cirrus,boost-cap-microfarad = <15>;
122 		cirrus,asp-sdout-hiz = <3>;
123 		cirrus,gpio2-src-select = <2>;
124 		cirrus,gpio2-output-enable;
125 		#sound-dai-cells = <1>;
131 		interrupt-parent = <&tlmm>;
133 		reset-gpios = <&tlmm 37 GPIO_ACTIVE_HIGH>;
134 		cirrus,boost-peak-milliamp = <4000>;
135 		cirrus,boost-ind-nanohenry = <1000>;
136 		cirrus,boost-cap-microfarad = <15>;
137 		cirrus,asp-sdout-hiz = <3>;
138 		cirrus,gpio2-src-select = <2>;
139 		cirrus,gpio2-output-enable;
140 		#sound-dai-cells = <1>;
147 	clock-frequency = <100000>;
155 	clock-frequency = <100000>;
163 	clock-frequency = <400000>;
170 	clock-frequency = <1000000>;
177 	memory-region = <&pil_ipa_fw_mem>;
178 	firmware-name = "qcom/ipa_fws.mbn";
183 	firmware-name = "qcom/modem.mbn";
213 	firmware-name = "qcom/slpi.mbn";
223 	gpio-reserved-ranges = <44 4>;
225 	ts_int_default: ts-int-default-state {
228 		drive-strength = <2>;
229 		bias-disable;
230 		input-enable;
238 /* TODO: Make USB3 work (perhaps needs regulators for higher-current operation?) */
242 	qcom,select-utmi-as-pipe-clk;
248 	maximum-speed = "high-speed";
250 	phy-names = "usb2-phy";