Lines Matching +full:spmi +full:- +full:adc +full:- +full:rev2

1 // SPDX-License-Identifier: BSD-3-Clause
6 #include <dt-bindings/iio/qcom,spmi-vadc.h>
7 #include <dt-bindings/input/linux-event-codes.h>
8 #include <dt-bindings/interrupt-controller/irq.h>
9 #include <dt-bindings/spmi/spmi.h>
10 #include <dt-bindings/thermal/thermal.h>
13 	thermal-zones {
15 			polling-delay-passive = <250>;
16 			polling-delay = <1000>;
18 			thermal-sensors = <&pm660_temp>;
21 				pm660_alert0: pm660-alert0 {
26 				pm660_crit: pm660-crit {
39 		compatible = "qcom,pm660", "qcom,spmi-pmic";
41 		#address-cells = <1>;
42 		#size-cells = <0>;
45 			compatible = "qcom,pm8941-rtc";
47 			reg-names = "rtc", "alarm";
52 			compatible = "qcom,pm8998-pon";
54 			mode-bootloader = <0x2>;
55 			mode-recovery = <0x1>;
58 				compatible = "qcom,pm8941-pwrkey";
61 				bias-pull-up;
68 				compatible = "qcom,pm8941-resin";
71 				bias-pull-up;
77 		pm660_temp: temp-alarm@2400 {
78 			compatible = "qcom,spmi-temp-alarm";
81 			io-channels = <&pm660_adc ADC5_DIE_TEMP>;
82 			io-channel-names = "thermal";
83 			#thermal-sensor-cells = <0>;
86 		pm660_adc: adc@3100 {
87 			compatible = "qcom,spmi-adc-rev2";
90 			#address-cells = <1>;
91 			#size-cells = <0>;
92 			#io-channel-cells = <1>;
97 				qcom,pre-scaling = <1 1>;
103 				qcom,pre-scaling = <1 1>;
109 				qcom,pre-scaling = <1 1>;
114 				qcom,pre-scaling = <1 1>;
116 				qcom,hw-settle-time = <200>;
122 				qcom,pre-scaling = <1 1>;
124 				qcom,hw-settle-time = <200>;
130 				qcom,pre-scaling = <1 1>;
132 				qcom,hw-settle-time = <200>;
138 				qcom,pre-scaling = <1 1>;
140 				qcom,hw-settle-time = <200>;
146 				qcom,pre-scaling = <1 1>;
148 				qcom,hw-settle-time = <200>;
154 				qcom,pre-scaling = <1 1>;
156 				qcom,hw-settle-time = <200>;
163 				qcom,pre-scaling = <1 3>;
169 				qcom,pre-scaling = <1 3>;
174 			compatible = "qcom,pm660-gpio", "qcom,spmi-gpio";
176 			gpio-controller;
177 			gpio-ranges = <&pm660_gpios 0 0 13>;
178 			#gpio-cells = <2>;
179 			interrupt-controller;
180 			#interrupt-cells = <2>;
185 		compatible = "qcom,pm660", "qcom,spmi-pmic";
187 		#address-cells = <1>;
188 		#size-cells = <0>;
191 			compatible = "qcom,pm660-regulators";