Lines Matching +full:dsr +full:- +full:gpios
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/input/linux-event-codes.h>
10 #include <dt-bindings/leds/common.h>
11 #include <dt-bindings/phy/phy-imx8-pcie.h>
17 compatible = "gw,imx8mm-gw7903", "fsl,imx8mm";
25 stdout-path = &uart2;
33 gpio-keys {
34 compatible = "gpio-keys";
36 key-user-pb {
38 gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
42 key-user-pb1x {
45 interrupt-parent = <&gsc>;
49 key-erased {
52 interrupt-parent = <&gsc>;
56 key-eeprom-wp {
59 interrupt-parent = <&gsc>;
63 switch-hold {
66 interrupt-parent = <&gsc>;
71 led-controller {
72 compatible = "gpio-leds";
73 pinctrl-names = "default";
74 pinctrl-0 = <&pinctrl_gpio_leds>;
76 led-0 {
80 gpios = <&gpio5 5 GPIO_ACTIVE_HIGH>;
81 default-state = "off";
84 led-1 {
88 gpios = <&gpio4 30 GPIO_ACTIVE_HIGH>;
89 default-state = "off";
92 led-2 {
96 gpios = <&gpio5 2 GPIO_ACTIVE_HIGH>;
97 default-state = "off";
100 led-3 {
104 gpios = <&gpio1 14 GPIO_ACTIVE_HIGH>;
105 default-state = "off";
108 led-4 {
112 gpios = <&gpio1 9 GPIO_ACTIVE_HIGH>;
113 default-state = "off";
116 led-5 {
120 gpios = <&gpio5 3 GPIO_ACTIVE_HIGH>;
121 default-state = "off";
124 led-6 {
128 gpios = <&gpio4 29 GPIO_ACTIVE_HIGH>;
129 default-state = "off";
132 led-7 {
136 gpios = <&gpio4 28 GPIO_ACTIVE_HIGH>;
137 default-state = "off";
140 led-8 {
144 gpios = <&gpio1 13 GPIO_ACTIVE_HIGH>;
145 default-state = "off";
148 led-9 {
152 gpios = <&gpio4 31 GPIO_ACTIVE_HIGH>;
153 default-state = "off";
156 led-a {
160 gpios = <&gpio5 4 GPIO_ACTIVE_HIGH>;
161 default-state = "off";
164 led-b {
168 gpios = <&gpio1 8 GPIO_ACTIVE_HIGH>;
169 default-state = "off";
173 pcie0_refclk: pcie0-refclk {
174 compatible = "fixed-clock";
175 #clock-cells = <0>;
176 clock-frequency = <100000000>;
179 reg_3p3v: regulator-3p3v {
180 compatible = "regulator-fixed";
181 regulator-name = "3P3V";
182 regulator-min-microvolt = <3300000>;
183 regulator-max-microvolt = <3300000>;
184 regulator-always-on;
189 cpu-supply = <&buck2>;
193 cpu-supply = <&buck2>;
197 cpu-supply = <&buck2>;
201 cpu-supply = <&buck2>;
205 operating-points-v2 = <&ddrc_opp_table>;
207 ddrc_opp_table: opp-table {
208 compatible = "operating-points-v2";
210 opp-25M {
211 opp-hz = /bits/ 64 <25000000>;
214 opp-100M {
215 opp-hz = /bits/ 64 <100000000>;
218 opp-750M {
219 opp-hz = /bits/ 64 <750000000>;
225 pinctrl-names = "default";
226 pinctrl-0 = <&pinctrl_fec1>;
227 phy-mode = "rgmii-id";
228 phy-handle = <ðphy0>;
229 local-mac-address = [00 00 00 00 00 00];
233 #address-cells = <1>;
234 #size-cells = <0>;
236 ethphy0: ethernet-phy@0 {
237 compatible = "ethernet-phy-ieee802.3-c22";
239 rx-internal-delay-ps = <2000>;
240 tx-internal-delay-ps = <2500>;
246 gpio-line-names = "", "", "", "", "", "", "", "",
253 gpio-line-names = "dig2_in", "dig2_out#", "dig2_ctl", "", "", "", "dig1_ctl", "",
260 gpio-line-names = "", "", "", "", "", "", "", "sim1_det#",
267 clock-frequency = <100000>;
268 pinctrl-names = "default";
269 pinctrl-0 = <&pinctrl_i2c1>;
275 pinctrl-0 = <&pinctrl_gsc>;
276 interrupt-parent = <&gpio4>;
278 interrupt-controller;
279 #interrupt-cells = <1>;
282 compatible = "gw,gsc-adc";
283 #address-cells = <1>;
284 #size-cells = <0>;
302 gw,voltage-divider-ohms = <22100 1000>;
303 gw,voltage-offset-microvolt = <700000>;
310 gw,voltage-divider-ohms = <10000 10000>;
317 gw,voltage-divider-ohms = <10000 10000>;
354 gw,voltage-divider-ohms = <10000 10000>;
362 gpio-controller;
363 #gpio-cells = <2>;
364 interrupt-parent = <&gsc>;
399 clock-frequency = <400000>;
400 pinctrl-names = "default";
401 pinctrl-0 = <&pinctrl_i2c2>;
407 pinctrl-names = "default";
408 pinctrl-0 = <&pinctrl_pmic>;
409 interrupt-parent = <&gpio3>;
411 rohm,reset-snvs-powered;
412 #clock-cells = <0>;
414 clock-output-names = "clk-32k-out";
417 /* vdd_soc: 0.805-0.900V (typ=0.8V) */
419 regulator-name = "buck1";
420 regulator-min-microvolt = <700000>;
421 regulator-max-microvolt = <1300000>;
422 regulator-boot-on;
423 regulator-always-on;
424 regulator-ramp-delay = <1250>;
427 /* vdd_arm: 0.805-1.0V (typ=0.9V) */
429 regulator-name = "buck2";
430 regulator-min-microvolt = <700000>;
431 regulator-max-microvolt = <1300000>;
432 regulator-boot-on;
433 regulator-always-on;
434 regulator-ramp-delay = <1250>;
435 rohm,dvs-run-voltage = <1000000>;
436 rohm,dvs-idle-voltage = <900000>;
439 /* vdd_0p9: 0.805-1.0V (typ=0.9V) */
441 regulator-name = "buck3";
442 regulator-min-microvolt = <700000>;
443 regulator-max-microvolt = <1350000>;
444 regulator-boot-on;
445 regulator-always-on;
450 regulator-name = "buck4";
451 regulator-min-microvolt = <3000000>;
452 regulator-max-microvolt = <3300000>;
453 regulator-boot-on;
454 regulator-always-on;
459 regulator-name = "buck5";
460 regulator-min-microvolt = <1605000>;
461 regulator-max-microvolt = <1995000>;
462 regulator-boot-on;
463 regulator-always-on;
468 regulator-name = "buck6";
469 regulator-min-microvolt = <800000>;
470 regulator-max-microvolt = <1400000>;
471 regulator-boot-on;
472 regulator-always-on;
477 regulator-name = "ldo1";
478 regulator-min-microvolt = <1600000>;
479 regulator-max-microvolt = <1900000>;
480 regulator-boot-on;
481 regulator-always-on;
486 regulator-name = "ldo2";
487 regulator-min-microvolt = <800000>;
488 regulator-max-microvolt = <900000>;
489 regulator-boot-on;
490 regulator-always-on;
495 regulator-name = "ldo3";
496 regulator-min-microvolt = <1800000>;
497 regulator-max-microvolt = <3300000>;
498 regulator-boot-on;
499 regulator-always-on;
503 regulator-name = "ldo4";
504 regulator-min-microvolt = <900000>;
505 regulator-max-microvolt = <1800000>;
506 regulator-boot-on;
507 regulator-always-on;
511 regulator-name = "ldo6";
512 regulator-min-microvolt = <900000>;
513 regulator-max-microvolt = <1800000>;
514 regulator-boot-on;
515 regulator-always-on;
522 clock-frequency = <400000>;
523 pinctrl-names = "default";
524 pinctrl-0 = <&pinctrl_i2c3>;
528 pinctrl-names = "default";
529 pinctrl-0 = <&pinctrl_accel>;
532 st,drdy-int-pin = <1>;
533 interrupt-parent = <&gpio1>;
535 interrupt-names = "INT1";
540 fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
541 fsl,clkreq-unsupported;
543 clock-names = "ref";
548 pinctrl-names = "default";
549 pinctrl-0 = <&pinctrl_pcie0>;
550 reset-gpio = <&gpio5 11 GPIO_ACTIVE_LOW>;
553 clock-names = "pcie", "pcie_aux", "pcie_bus";
554 assigned-clocks = <&clk IMX8MM_CLK_PCIE1_AUX>,
556 assigned-clock-rates = <10000000>, <250000000>;
557 assigned-clock-parents = <&clk IMX8MM_SYS_PLL2_50M>,
566 /* off-board RS232/RS485/RS422 */
568 pinctrl-names = "default";
569 pinctrl-0 = <&pinctrl_uart1>;
570 cts-gpios = <&gpio1 3 GPIO_ACTIVE_LOW>;
571 rts-gpios = <&gpio1 5 GPIO_ACTIVE_LOW>;
572 dtr-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
573 dsr-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>;
574 dcd-gpios = <&gpio3 24 GPIO_ACTIVE_LOW>;
575 uart-has-rtscts;
581 pinctrl-names = "default";
582 pinctrl-0 = <&pinctrl_uart2>;
588 disable-over-current;
594 pinctrl-names = "default", "state_100mhz", "state_200mhz";
595 pinctrl-0 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
596 pinctrl-1 = <&pinctrl_usdhc2_100mhz>, <&pinctrl_usdhc2_gpio>;
597 pinctrl-2 = <&pinctrl_usdhc2_200mhz>, <&pinctrl_usdhc2_gpio>;
598 cd-gpios = <&gpio2 12 GPIO_ACTIVE_LOW>;
599 bus-width = <4>;
600 vmmc-supply = <®_3p3v>;
606 pinctrl-names = "default", "state_100mhz", "state_200mhz";
607 pinctrl-0 = <&pinctrl_usdhc3>;
608 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
609 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
610 bus-width = <8>;
611 non-removable;
616 pinctrl-names = "default";
617 pinctrl-0 = <&pinctrl_wdog>;
618 fsl,ext-reset-output;
623 pinctrl-names = "default";
624 pinctrl-0 = <&pinctrl_hog>;
757 pinctrl_usdhc2_100mhz: usdhc2-100mhzgrp {
768 pinctrl_usdhc2_200mhz: usdhc2-200mhzgrp {
779 pinctrl_usdhc2_gpio: usdhc2-gpiogrp {
802 pinctrl_usdhc3_100mhz: usdhc3-100mhzgrp {
818 pinctrl_usdhc3_200mhz: usdhc3-200mhzgrp {