Lines Matching +full:drdy +full:- +full:int +full:- +full:pin
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/leds/common.h>
8 #include <dt-bindings/phy/phy-imx8-pcie.h>
17 led-controller {
18 compatible = "gpio-leds";
19 pinctrl-names = "default";
20 pinctrl-0 = <&pinctrl_gpio_leds>;
22 led-0 {
26 default-state = "on";
27 linux,default-trigger = "heartbeat";
30 led-1 {
34 default-state = "off";
38 pcie0_refclk: pcie0-refclk {
39 compatible = "fixed-clock";
40 #clock-cells = <0>;
41 clock-frequency = <100000000>;
45 compatible = "pps-gpio";
46 pinctrl-names = "default";
47 pinctrl-0 = <&pinctrl_pps>;
52 reg_1p8v: regulator-1p8v {
53 compatible = "regulator-fixed";
54 regulator-name = "1P8V";
55 regulator-min-microvolt = <1800000>;
56 regulator-max-microvolt = <1800000>;
57 regulator-always-on;
60 reg_3p3v: regulator-3p3v {
61 compatible = "regulator-fixed";
62 regulator-name = "3P3V";
63 regulator-min-microvolt = <3300000>;
64 regulator-max-microvolt = <3300000>;
65 regulator-always-on;
68 reg_usb_otg1_vbus: regulator-usb-otg1 {
69 pinctrl-names = "default";
70 pinctrl-0 = <&pinctrl_reg_usb1_en>;
71 compatible = "regulator-fixed";
72 regulator-name = "usb_otg1_vbus";
74 enable-active-high;
75 regulator-min-microvolt = <5000000>;
76 regulator-max-microvolt = <5000000>;
79 reg_usb_otg2_vbus: regulator-usb-otg2 {
80 pinctrl-names = "default";
81 pinctrl-0 = <&pinctrl_reg_usb2_en>;
82 compatible = "regulator-fixed";
83 regulator-name = "usb_otg2_vbus";
85 enable-active-high;
86 regulator-min-microvolt = <5000000>;
87 regulator-max-microvolt = <5000000>;
90 reg_wifi_en: regulator-wifi-en {
91 pinctrl-names = "default";
92 pinctrl-0 = <&pinctrl_reg_wl>;
93 compatible = "regulator-fixed";
94 regulator-name = "wl";
96 startup-delay-us = <100>;
97 enable-active-high;
98 regulator-min-microvolt = <3300000>;
99 regulator-max-microvolt = <3300000>;
103 /* off-board header */
105 pinctrl-names = "default";
106 pinctrl-0 = <&pinctrl_spi2>;
107 cs-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>;
112 gpio-line-names = "rs485_term", "mipi_gpio4", "", "",
120 gpio-line-names = "rs485_en", "mipi_gpio3", "rs485_hd", "mipi_gpio2",
128 clock-frequency = <400000>;
129 pinctrl-names = "default";
130 pinctrl-0 = <&pinctrl_i2c2>;
134 pinctrl-names = "default";
135 pinctrl-0 = <&pinctrl_accel>;
138 st,drdy-int-pin = <1>;
139 interrupt-parent = <&gpio4>;
141 interrupt-names = "INT1";
145 /* off-board header */
147 clock-frequency = <400000>;
148 pinctrl-names = "default";
149 pinctrl-0 = <&pinctrl_i2c3>;
154 fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
155 fsl,clkreq-unsupported;
157 clock-names = "ref";
162 pinctrl-names = "default";
163 pinctrl-0 = <&pinctrl_pcie0>;
164 reset-gpio = <&gpio4 6 GPIO_ACTIVE_LOW>;
167 clock-names = "pcie", "pcie_aux", "pcie_bus";
168 assigned-clocks = <&clk IMX8MM_CLK_PCIE1_AUX>,
170 assigned-clock-rates = <10000000>, <250000000>;
171 assigned-clock-parents = <&clk IMX8MM_SYS_PLL2_50M>,
177 #address-cells = <1>;
178 #size-cells = <0>;
182 #address-cells = <1>;
183 #size-cells = <0>;
187 #address-cells = <1>;
188 #size-cells = <0>;
192 #address-cells = <1>;
193 #size-cells = <0>;
195 local-mac-address = [00 00 00 00 00 00];
202 /* off-board header */
204 pinctrl-names = "default";
205 pinctrl-0 = <&pinctrl_sai3>;
206 assigned-clocks = <&clk IMX8MM_CLK_SAI3>;
207 assigned-clock-parents = <&clk IMX8MM_AUDIO_PLL1_OUT>;
208 assigned-clock-rates = <24576000>;
214 pinctrl-names = "default";
215 pinctrl-0 = <&pinctrl_uart1>;
221 pinctrl-names = "default";
222 pinctrl-0 = <&pinctrl_uart3>, <&pinctrl_bten>;
223 cts-gpios = <&gpio5 8 GPIO_ACTIVE_LOW>;
224 rts-gpios = <&gpio5 9 GPIO_ACTIVE_LOW>;
225 uart-has-rtscts;
229 compatible = "brcm,bcm4330-bt";
230 shutdown-gpios = <&gpio1 3 GPIO_ACTIVE_HIGH>;
236 pinctrl-names = "default";
237 pinctrl-0 = <&pinctrl_uart4>;
243 over-current-active-low;
244 vbus-supply = <®_usb_otg1_vbus>;
250 disable-over-current;
251 vbus-supply = <®_usb_otg2_vbus>;
257 pinctrl-names = "default";
258 pinctrl-0 = <&pinctrl_usdhc1>;
259 bus-width = <4>;
260 non-removable;
261 vmmc-supply = <®_wifi_en>;
267 pinctrl-names = "default", "state_100mhz", "state_200mhz";
268 pinctrl-0 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
269 pinctrl-1 = <&pinctrl_usdhc2_100mhz>, <&pinctrl_usdhc2_gpio>;
270 pinctrl-2 = <&pinctrl_usdhc2_200mhz>, <&pinctrl_usdhc2_gpio>;
271 cd-gpios = <&gpio2 12 GPIO_ACTIVE_LOW>;
272 bus-width = <4>;
273 vmmc-supply = <®_3p3v>;
278 pinctrl-names = "default";
279 pinctrl-0 = <&pinctrl_hog>;
415 pinctrl_usdhc2_100mhz: usdhc2-100mhzgrp {
426 pinctrl_usdhc2_200mhz: usdhc2-200mhzgrp {