Lines Matching +full:regulator +full:- +full:over +full:- +full:current +full:- +full:protection
1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
3 * Copyright (C) 2019-2020 Marek Vasut <marex@denx.de>
6 #include "stm32mp15-pinctrl.dtsi"
7 #include "stm32mp15xxaa-pinctrl.dtsi"
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/mfd/st,stpmic1.h>
24 reserved-memory {
25 #address-cells = <1>;
26 #size-cells = <1>;
30 compatible = "shared-dma-pool";
32 no-map;
36 compatible = "shared-dma-pool";
38 no-map;
42 compatible = "shared-dma-pool";
44 no-map;
48 compatible = "shared-dma-pool";
50 no-map;
54 compatible = "shared-dma-pool";
56 no-map;
60 compatible = "shared-dma-pool";
62 no-map;
67 compatible = "regulator-fixed";
68 regulator-name = "vio";
69 regulator-min-microvolt = <3300000>;
70 regulator-max-microvolt = <3300000>;
72 regulator-always-on;
73 regulator-boot-on;
74 vin-supply = <&vdd>;
79 vdd-supply = <&vdd>;
80 vdda-supply = <&vdda>;
81 vref-supply = <&vdda>;
85 st,min-sample-time-nsecs = <5000>;
86 st,adc-channels = <0>;
91 st,adc-channels = <1>;
92 st,min-sample-time-nsecs = <5000>;
102 pinctrl-names = "default";
103 pinctrl-0 = <&dac_ch1_pins_a &dac_ch2_pins_a>;
104 vref-supply = <&vdda>;
121 pinctrl-0 = <ðernet0_rmii_pins_c &mco2_pins_a>;
122 pinctrl-1 = <ðernet0_rmii_sleep_pins_c &mco2_sleep_pins_a>;
123 pinctrl-names = "default", "sleep";
124 phy-mode = "rmii";
125 max-speed = <100>;
126 phy-handle = <&phy0>;
129 #address-cells = <1>;
130 #size-cells = <0>;
131 compatible = "snps,dwmac-mdio";
133 phy0: ethernet-phy@1 {
136 compatible = "ethernet-phy-id0007.c0f0",
137 "ethernet-phy-ieee802.3-c22";
139 reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
140 reset-assert-us = <500>;
141 reset-deassert-us = <500>;
142 smsc,disable-energy-detect;
143 interrupt-parent = <&gpioi>;
150 pinctrl-names = "default", "sleep";
151 pinctrl-0 = <&fmc_pins_b>;
152 pinctrl-1 = <&fmc_sleep_pins_b>;
156 compatible = "micrel,ks8851-mll";
158 interrupt-parent = <&gpioc>;
160 bank-width = <2>;
163 st,fmc2-ebi-cs-mux-enable;
164 st,fmc2-ebi-cs-transaction-type = <4>;
165 st,fmc2-ebi-cs-buswidth = <16>;
166 st,fmc2-ebi-cs-address-setup-ns = <5>;
167 st,fmc2-ebi-cs-address-hold-ns = <5>;
168 st,fmc2-ebi-cs-bus-turnaround-ns = <5>;
169 st,fmc2-ebi-cs-data-setup-ns = <45>;
170 st,fmc2-ebi-cs-data-hold-ns = <1>;
171 st,fmc2-ebi-cs-write-address-setup-ns = <5>;
172 st,fmc2-ebi-cs-write-address-hold-ns = <5>;
173 st,fmc2-ebi-cs-write-bus-turnaround-ns = <5>;
174 st,fmc2-ebi-cs-write-data-setup-ns = <45>;
175 st,fmc2-ebi-cs-write-data-hold-ns = <1>;
180 gpio-line-names = "", "", "", "",
181 "", "", "DHCOM-K", "",
187 gpio-line-names = "", "", "", "",
189 "DHCOM-Q", "", "", "",
194 gpio-line-names = "", "", "", "",
195 "", "", "DHCOM-E", "",
201 gpio-line-names = "", "", "", "",
202 "", "", "DHCOM-B", "",
203 "", "", "", "DHCOM-F",
204 "DHCOM-D", "", "", "";
208 gpio-line-names = "", "", "", "",
209 "", "", "DHCOM-P", "",
215 gpio-line-names = "", "", "", "DHCOM-A",
222 gpio-line-names = "DHCOM-C", "", "", "",
224 "DHCOM-L", "", "", "",
229 gpio-line-names = "", "", "", "",
230 "", "", "", "DHCOM-N",
231 "DHCOM-J", "DHCOM-W", "DHCOM-V", "DHCOM-U",
232 "DHCOM-T", "", "DHCOM-S", "";
236 gpio-line-names = "DHCOM-G", "DHCOM-O", "DHCOM-H", "DHCOM-I",
237 "DHCOM-R", "DHCOM-M", "", "",
243 pinctrl-names = "default";
244 pinctrl-0 = <&i2c4_pins_a>;
245 i2c-scl-rising-time-ns = <185>;
246 i2c-scl-falling-time-ns = <20>;
249 /delete-property/dmas;
250 /delete-property/dma-names;
260 interrupts-extended = <&gpioa 0 IRQ_TYPE_EDGE_FALLING>;
261 interrupt-controller;
262 #interrupt-cells = <2>;
266 compatible = "st,stpmic1-regulators";
267 ldo1-supply = <&v3v3>;
268 ldo2-supply = <&v3v3>;
269 ldo3-supply = <&vdd_ddr>;
270 ldo5-supply = <&v3v3>;
271 ldo6-supply = <&v3v3>;
272 pwr_sw1-supply = <&bst_out>;
273 pwr_sw2-supply = <&bst_out>;
276 regulator-name = "vddcore";
277 regulator-min-microvolt = <800000>;
278 regulator-max-microvolt = <1350000>;
279 regulator-always-on;
280 regulator-initial-mode = <0>;
281 regulator-over-current-protection;
285 regulator-name = "vdd_ddr";
286 regulator-min-microvolt = <1350000>;
287 regulator-max-microvolt = <1350000>;
288 regulator-always-on;
289 regulator-initial-mode = <0>;
290 regulator-over-current-protection;
294 regulator-name = "vdd";
295 regulator-min-microvolt = <3300000>;
296 regulator-max-microvolt = <3300000>;
297 regulator-always-on;
298 st,mask-reset;
299 regulator-initial-mode = <0>;
300 regulator-over-current-protection;
304 regulator-name = "v3v3";
305 regulator-min-microvolt = <3300000>;
306 regulator-max-microvolt = <3300000>;
307 regulator-always-on;
308 regulator-over-current-protection;
309 regulator-initial-mode = <0>;
313 regulator-name = "vdda";
314 regulator-always-on;
315 regulator-min-microvolt = <2900000>;
316 regulator-max-microvolt = <2900000>;
321 regulator-name = "v2v8";
322 regulator-min-microvolt = <2800000>;
323 regulator-max-microvolt = <2800000>;
328 regulator-name = "vtt_ddr";
329 regulator-min-microvolt = <500000>;
330 regulator-max-microvolt = <750000>;
331 regulator-always-on;
332 regulator-over-current-protection;
336 regulator-name = "vdd_usb";
341 regulator-name = "vdd_sd";
342 regulator-min-microvolt = <2900000>;
343 regulator-max-microvolt = <2900000>;
345 regulator-boot-on;
349 regulator-name = "v1v8";
350 regulator-min-microvolt = <1800000>;
351 regulator-max-microvolt = <1800000>;
356 regulator-name = "vref_ddr";
357 regulator-always-on;
361 regulator-name = "bst_out";
366 regulator-name = "vbus_otg";
371 regulator-name = "vbus_sw";
373 regulator-active-discharge = <1>;
378 compatible = "st,stpmic1-onkey";
380 interrupt-names = "onkey-falling", "onkey-rising";
381 power-off-time-sec = <10>;
386 compatible = "st,stpmic1-wdt";
394 vio-supply = <&v3v3>;
395 interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>;
410 timeout-sec = <32>;
415 memory-region = <&retram>, <&mcuram>, <&mcuram2>, <&vdev0vring0>,
418 mbox-names = "vq0", "vq1", "shutdown";
419 interrupt-parent = <&exti>;
425 vdd-supply = <&vdd>;
426 vdd_3v3_usbfs-supply = <&vdd_usb>;
430 pinctrl-names = "default", "sleep";
431 pinctrl-0 = <&qspi_clk_pins_a &qspi_bk1_pins_a>;
432 pinctrl-1 = <&qspi_clk_sleep_pins_a &qspi_bk1_sleep_pins_a>;
434 #address-cells = <1>;
435 #size-cells = <0>;
439 compatible = "jedec,spi-nor";
441 spi-rx-bus-width = <4>;
442 spi-max-frequency = <108000000>;
443 #address-cells = <1>;
444 #size-cells = <1>;
449 /* Connect MCO2 output to ETH_RX_CLK input via pad-pad connection */
451 clock-names = "ETH_RX_CLK/ETH_REF_CLK";
458 assigned-clocks = <&rcc CK_MCO2>, <&rcc PLL4_P>;
459 assigned-clock-parents = <&rcc PLL4_P>;
460 assigned-clock-rates = <50000000>, <100000000>;
472 pinctrl-names = "default", "opendrain", "sleep", "init";
473 pinctrl-0 = <&sdmmc1_b4_pins_a &sdmmc1_dir_pins_a>;
474 pinctrl-1 = <&sdmmc1_b4_od_pins_a &sdmmc1_dir_pins_a>;
475 pinctrl-2 = <&sdmmc1_b4_sleep_pins_a &sdmmc1_dir_sleep_pins_a>;
476 pinctrl-3 = <&sdmmc1_b4_init_pins_a &sdmmc1_dir_init_pins_a>;
477 cd-gpios = <&gpiog 1 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
478 disable-wp;
479 st,sig-dir;
480 st,neg-edge;
481 st,use-ckin;
482 st,cmd-gpios = <&gpiod 2 0>;
483 st,ck-gpios = <&gpioc 12 0>;
484 st,ckin-gpios = <&gpioe 4 0>;
485 bus-width = <4>;
486 vmmc-supply = <&vdd_sd>;
492 * SD bus pull-up resistors:
493 * - optional on SoMs with SD voltage translator
494 * - mandatory on SoMs without SD voltage translator
497 bias-pull-up;
500 bias-pull-up;
505 pinctrl-names = "default", "opendrain", "sleep";
506 pinctrl-0 = <&sdmmc2_b4_pins_a &sdmmc2_d47_pins_a>;
507 pinctrl-1 = <&sdmmc2_b4_od_pins_a &sdmmc2_d47_pins_a>;
508 pinctrl-2 = <&sdmmc2_b4_sleep_pins_a &sdmmc2_d47_sleep_pins_a>;
509 non-removable;
510 no-sd;
511 no-sdio;
512 st,neg-edge;
513 bus-width = <8>;
514 vmmc-supply = <&v3v3>;
515 vqmmc-supply = <&v3v3>;
516 mmc-ddr-3_3v;
521 pinctrl-names = "default", "opendrain", "sleep";
522 pinctrl-0 = <&sdmmc3_b4_pins_a>;
523 pinctrl-1 = <&sdmmc3_b4_od_pins_a>;
524 pinctrl-2 = <&sdmmc3_b4_sleep_pins_a>;
525 broken-cd;
526 st,neg-edge;
527 bus-width = <4>;
528 vmmc-supply = <&v3v3>;
529 vqmmc-supply = <&v3v3>;
530 mmc-ddr-3_3v;
535 pinctrl-names = "default";
536 pinctrl-0 = <&uart4_pins_a>;
537 /delete-property/dmas;
538 /delete-property/dma-names;