Lines Matching +full:gpio +full:- +full:line +full:- +full:names
1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 #include "ste-href-ab8500.dtsi"
7 #include "ste-href.dtsi"
10 model = "ST-Ericsson HREF (v60+) platform with Device Tree";
11 compatible = "st-ericsson,hrefv60+", "st-ericsson,u8500";
13 thermal-zones {
14 chassis-thermal {
16 polling-delay = <20000>;
18 polling-delay-passive = <2000>;
20 thermal-sensors = <&therm1>, <&therm2>;
24 chassis_alert: chassis-alert {
30 chassis_crit: chassis-crit {
39 cooling-maps {
42 cooling-device = <&CPU0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
55 io-channels = <&gpadc 0x06>; /* AUX1 */
56 pullup-uv = <1800000>;
57 pullup-ohm = <220000>;
58 pulldown-ohm = <0>;
59 #thermal-sensor-cells = <0>;
64 io-channels = <&gpadc 0x07>; /* AUX2 */
65 pullup-uv = <1800000>;
66 pullup-ohm = <220000>;
67 pulldown-ohm = <0>;
68 #thermal-sensor-cells = <0>;
72 /* Name the GPIO muxed rails on the HREF boards */
73 gpio@8012e000 {
74 /* GPIOs 0 - 31 */
75 gpio-line-names =
95 gpio@8012e080 {
96 /* GPIOs 32 - 63 */
97 gpio-line-names =
105 gpio@8000e000 {
106 /* GPIOs 64 - 95 */
107 gpio-line-names = "XENON_EN2 (FLASH_CTRL_4)",
113 /* GPIO 70-77 used for ETM */
115 /* GPIO 78-81 used for YCBCR */
128 gpio@8000e080 {
129 /* GPIOs 96 - 127 */
130 gpio-line-names = "",
138 gpio@8000e100 {
139 /* GPIOs 128 - 159 */
140 gpio-line-names = "", "", "", "", "", "", "", "",
155 gpio@8000e180 {
156 /* GPIOs 160 - 191 */
157 gpio-line-names = "", "", "", "", "", "", "", "",
167 gpio@8011e000 {
168 /* GPIOs 192 - 223 */
169 gpio-line-names = "HDTV_INTN",
175 /* GPIO208-216 used for WGBF_MC1 */
182 gpio@8011e080 {
183 /* GPIOs 224 - 255 */
184 gpio-line-names = "", "",
194 cd-gpios = <&gpio2 31 GPIO_ACTIVE_HIGH>; // 95
202 pinctrl-names = "default";
203 pinctrl-0 = <&ipgpio_hrefv60_mode>,
216 /* SD card detect GPIO pin, extend default state */
225 * XENON Flashgun on image processor GPIO (controlled from image
226 * processor firmware), mux in these image processor GPIO lines 0
228 * LED on IP GPIO 4 (XENON_EN2) on altfunction C, that need bias
252 * Drive D19-D23 for the ETM PTM trace interface low,
283 /* NFC ENA and RESET to low, pulldown IRQ line */
320 /* Audio Amplifier HF enable GPIO */
330 * GBF (GPS, Bluetooth, FM-radio) interface,
341 /* MSP : HDTV INTERFACE GPIO line */
351 * Display Interface 1 uses GPIO 65 for RST (reset).
352 * Display Interface 2 uses GPIO 66 for RST (reset).
366 /* Dangling GPIO pins */