Lines Matching +full:ether +full:- +full:r8a7790
1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
9 #include "r8a7790.dtsi"
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/input/input.h>
15 compatible = "renesas,stout", "renesas,r8a7790";
23 stdout-path = "serial0:115200n8";
32 compatible = "gpio-leds";
47 fixedregulator3v3: regulator-3v3 {
48 compatible = "regulator-fixed";
49 regulator-name = "fixed-3.3V";
50 regulator-min-microvolt = <3300000>;
51 regulator-max-microvolt = <3300000>;
52 regulator-boot-on;
53 regulator-always-on;
56 vcc_sdhi0: regulator-vcc-sdhi0 {
57 compatible = "regulator-fixed";
59 regulator-name = "SDHI0 Vcc";
60 regulator-min-microvolt = <3300000>;
61 regulator-max-microvolt = <3300000>;
64 enable-active-high;
67 hdmi-out {
68 compatible = "hdmi-connector";
73 remote-endpoint = <&adv7511_out>;
78 osc1_clk: osc1-clock {
79 compatible = "fixed-clock";
80 #clock-cells = <0>;
81 clock-frequency = <148500000>;
84 osc4_clk: osc4-clock {
85 compatible = "fixed-clock";
86 #clock-cells = <0>;
87 clock-frequency = <12000000>;
92 pinctrl-0 = <&du_pins>;
93 pinctrl-names = "default";
98 clock-names = "du.0", "du.1", "du.2", "dclkin.0";
103 remote-endpoint = <&adv7511_in>;
128 clock-frequency = <20000000>;
133 pinctrl-0 = <&scif_clk_pins>;
134 pinctrl-names = "default";
151 ether_pins: ether {
164 power-source = <3300>;
193 ðer {
194 pinctrl-0 = <ðer_pins>, <&phy1_pins>;
195 pinctrl-names = "default";
197 phy-handle = <&phy1>;
198 renesas,ether-link-active-low;
201 phy1: ethernet-phy@1 {
202 compatible = "ethernet-phy-id0022.1537",
203 "ethernet-phy-ieee802.3-c22";
205 interrupt-parent = <&irqc0>;
207 micrel,led-mode = <1>;
208 reset-gpios = <&gpio3 31 GPIO_ACTIVE_LOW>;
217 pinctrl-0 = <&qspi_pins>;
218 pinctrl-names = "default";
223 compatible = "spansion,s25fl512s", "jedec,spi-nor";
225 spi-max-frequency = <30000000>;
226 spi-tx-bus-width = <4>;
227 spi-rx-bus-width = <4>;
228 spi-cpha;
229 spi-cpol;
230 m25p,fast-read;
233 compatible = "fixed-partitions";
234 #address-cells = <1>;
235 #size-cells = <1>;
240 read-only;
245 read-only;
248 label = "uboot-env";
250 read-only;
261 pinctrl-0 = <&scifa0_pins>;
262 pinctrl-names = "default";
268 clock-frequency = <14745600>;
272 pinctrl-0 = <&sdhi0_pins>;
273 pinctrl-names = "default";
275 vmmc-supply = <&vcc_sdhi0>;
276 cd-gpios = <&gpio3 6 GPIO_ACTIVE_LOW>;
281 cpu0-supply = <&vdd_dvfs>;
286 pinctrl-0 = <&iic2_pins>;
287 pinctrl-names = "default";
289 clock-frequency = <100000>;
294 interrupt-parent = <&gpio1>;
297 clock-names = "cec";
299 adi,input-depth = <8>;
300 adi,input-colorspace = "rgb";
301 adi,input-clock = "1x";
304 #address-cells = <1>;
305 #size-cells = <0>;
310 remote-endpoint = <&du_out_rgb>;
317 remote-endpoint = <&hdmi_con_out>;
325 pinctrl-names = "default";
326 pinctrl-0 = <&iic3_pins>, <&pmic_irq_pins>;
332 interrupt-parent = <&irqc0>;
334 interrupt-controller;
337 compatible = "dlg,da9063-onkey";
341 compatible = "dlg,da9063-rtc";
345 compatible = "dlg,da9063-watchdog";
352 interrupt-parent = <&irqc0>;
355 regulator-min-microvolt = <1000000>;
356 regulator-max-microvolt = <1000000>;
357 regulator-boot-on;
358 regulator-always-on;
364 interrupt-parent = <&irqc0>;
367 regulator-min-microvolt = <1000000>;
368 regulator-max-microvolt = <1000000>;
369 regulator-boot-on;
370 regulator-always-on;
376 pinctrl-0 = <&usb0_pins>;
377 pinctrl-names = "default";