Lines Matching +full:spmi +full:- +full:vadc
1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/interrupt-controller/irq.h>
4 #include <dt-bindings/spmi/spmi.h>
9 compatible = "qcom,pm8941", "qcom,spmi-pmic";
11 #address-cells = <1>;
12 #size-cells = <0>;
15 compatible = "qcom,pm8941-rtc";
18 reg-names = "rtc", "alarm";
23 compatible = "qcom,pm8941-pwrkey";
27 bias-pull-up;
31 compatible = "qcom,pm8941-misc";
34 interrupt-names = "usb_id";
38 compatible = "qcom,pm8941-charger";
48 interrupt-names = "chg-done",
49 "chg-fast",
50 "chg-trkl",
51 "bat-temp-ok",
52 "bat-present",
53 "chg-gone",
54 "usb-valid",
55 "dc-valid";
57 usb-otg-in-supply = <&pm8941_5vs1>;
59 chg_otg: otg-vbus { };
63 compatible = "qcom,pm8941-gpio", "qcom,spmi-gpio";
65 gpio-controller;
66 gpio-ranges = <&pm8941_gpios 0 0 36>;
67 #gpio-cells = <2>;
68 interrupt-controller;
69 #interrupt-cells = <2>;
71 boost_bypass_n_pin: boost-bypass-state {
78 compatible = "qcom,pm8941-mpp", "qcom,spmi-mpp";
80 gpio-controller;
81 #gpio-cells = <2>;
82 gpio-ranges = <&pm8941_mpps 0 0 8>;
83 interrupt-controller;
84 #interrupt-cells = <2>;
87 pm8941_temp: temp-alarm@2400 {
88 compatible = "qcom,spmi-temp-alarm";
91 io-channels = <&pm8941_vadc VADC_DIE_TEMP>;
92 io-channel-names = "thermal";
93 #thermal-sensor-cells = <0>;
97 compatible = "qcom,spmi-vadc";
100 #address-cells = <1>;
101 #size-cells = <0>;
102 #io-channel-cells = <1>;
128 compatible = "qcom,pm8941-iadc", "qcom,spmi-iadc";
131 qcom,external-resistor-micro-ohms = <10000>;
135 compatible = "qcom,pm8941-coincell";
142 compatible = "qcom,pm8941", "qcom,spmi-pmic";
144 #address-cells = <1>;
145 #size-cells = <0>;
148 compatible = "qcom,pm8941-lpg";
150 #address-cells = <1>;
151 #size-cells = <0>;
152 #pwm-cells = <2>;
158 compatible = "qcom,pm8941-wled";
166 compatible = "qcom,pm8941-regulators";
168 interrupt-names = "ocp-5vs1", "ocp-5vs2";
169 vin_5vs-supply = <&pm8941_5v>;
172 regulator-min-microvolt = <5000000>;
173 regulator-max-microvolt = <5000000>;
174 regulator-enable-ramp-delay = <500>;
178 regulator-enable-ramp-delay = <1000>;
179 regulator-pull-down;
180 regulator-over-current-protection;
181 qcom,ocp-max-retries = <10>;
182 qcom,ocp-retry-delay = <30>;
183 qcom,vs-soft-start-strength = <0>;
184 regulator-initial-mode = <1>;
188 regulator-enable-ramp-delay = <1000>;
189 regulator-pull-down;
190 regulator-over-current-protection;
191 qcom,ocp-max-retries = <10>;
192 qcom,ocp-retry-delay = <30>;
193 qcom,vs-soft-start-strength = <0>;
194 regulator-initial-mode = <1>;