Lines Matching +full:bb +full:- +full:uamp
1 // SPDX-License-Identifier: GPL-2.0-only
5 * Based on omap3-beagle-xm.dts
7 /dts-v1/;
10 #include <dt-bindings/input/input.h>
14 compatible = "ti,omap3-gta04", "ti,omap3630", "ti,omap36xx", "ti,omap3";
18 cpu0-supply = <&vcc>;
28 stdout-path = &uart3;
34 /delete-property/ mmc2;
35 /delete-property/ mmc3;
39 compatible = "regulator-fixed";
40 regulator-name = "ldo_3v3";
41 regulator-min-microvolt = <3300000>;
42 regulator-max-microvolt = <3300000>;
43 regulator-always-on;
48 #clock-cells = <0>;
49 compatible = "fixed-clock";
50 clock-frequency = <26000000>;
53 gpio-keys {
54 compatible = "gpio-keys";
56 aux-button {
60 wakeup-source;
64 antenna-detect {
65 compatible = "gpio-keys";
67 gps_antenna_button: gps-antenna-button {
69 linux,input-type = <EV_SW>;
72 interrupt-parent = <&gpio5>;
74 debounce-interval = <10>;
75 wakeup-source;
80 compatible = "ti,omap-twl4030";
88 compatible = "simple-audio-card";
89 simple-audio-card,name = "GTA04 voice";
90 simple-audio-card,bitclock-master = <&telephony_link_master>;
91 simple-audio-card,frame-master = <&telephony_link_master>;
92 simple-audio-card,format = "i2s";
93 simple-audio-card,bitclock-inversion;
94 simple-audio-card,frame-inversion;
95 simple-audio-card,cpu {
96 sound-dai = <&mcbsp4>;
99 telephony_link_master: simple-audio-card,codec {
100 sound-dai = <>m601_codec>;
106 #sound-dai-cells = <0>;
110 compatible = "spi-gpio";
111 #address-cells = <0x1>;
112 #size-cells = <0x0>;
113 pinctrl-names = "default";
114 pinctrl-0 = <&spi_gpio_pins>;
116 sck-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
117 miso-gpios = <&gpio1 18 GPIO_ACTIVE_HIGH>;
118 mosi-gpios = <&gpio1 20 GPIO_ACTIVE_HIGH>;
119 cs-gpios = <&gpio1 19 GPIO_ACTIVE_LOW>;
120 num-chipselects = <1>;
126 spi-max-frequency = <100000>;
127 spi-cpol;
128 spi-cpha;
134 remote-endpoint = <&dpi_out>;
141 compatible = "pwm-backlight";
143 pwm-names = "backlight";
144 brightness-levels = <0 11 20 30 40 50 60 70 80 90 100>;
145 default-brightness-level = <9>; /* => 90 */
146 pinctrl-names = "default";
147 pinctrl-0 = <&backlight_pins>;
150 pwm11: dmtimer-pwm {
151 compatible = "ti,omap-dmtimer-pwm";
153 #pwm-cells = <3>;
154 ti,clock-source = <0x01>;
158 compatible = "usb-nop-xceiv";
159 reset-gpios = <&gpio6 14 GPIO_ACTIVE_LOW>;
160 #phy-cells = <0>;
164 compatible = "composite-video-connector";
169 remote-endpoint = <&opa_out>;
176 enable-gpios = <&gpio1 23 GPIO_ACTIVE_HIGH>; /* GPIO_23 to enable video out amplifier */
179 #address-cells = <1>;
180 #size-cells = <0>;
185 remote-endpoint = <&venc_out>;
192 remote-endpoint = <&tv_connector_in>;
199 compatible = "mmc-pwrseq-simple";
200 reset-gpios = <&tca6507 0 GPIO_ACTIVE_LOW>; /* W2CBW003 reset through tca6507 */
205 compatible = "pinctrl-single";
207 #address-cells = <1>;
208 #size-cells = <0>;
209 pinctrl-single,bit-per-mux;
210 pinctrl-single,register-width = <32>;
211 pinctrl-single,function-mask = <0x7>; /* MCBSP1 CLK pinmux */
212 #pinctrl-cells = <2>;
213 pinctrl-names = "default";
214 pinctrl-0 = <&mcbsp1_devconf0_pins>;
217 pinctrl-single,bits = <0x00 0x08 0x1c>; /* set MCBSP1_CLKR */
223 compatible = "pinctrl-single";
225 #address-cells = <1>;
226 #size-cells = <0>;
227 pinctrl-single,bit-per-mux;
228 pinctrl-single,register-width = <32>;
229 pinctrl-single,function-mask = <0x81>; /* TV out pin control */
230 #pinctrl-cells = <2>;
231 pinctrl-names = "default";
232 pinctrl-0 = <&tv_acbias_devconf1_pins>;
235 pinctrl-single,bits = <0x00 0x40800 0x40800>; /* set TVOUTBYPASS and TVOUTACEN */
242 pinctrl-single,pins = <
250 pinctrl-names = "default";
251 pinctrl-0 = <
256 pinctrl-single,pins = <
267 pinctrl-single,pins = <
274 pinctrl-single,pins = <
281 pinctrl-single,pins = <
288 pinctrl-single,pins = <
299 pinctrl-single,pins = <
305 pinctrl-single,pins = <
338 pinctrl-single,pins = <
344 pinctrl-single,pins = <
350 pinctrl-single,pins = <
356 pinctrl-single,pins = <
362 pinctrl-single,pins = <
368 pinctrl-single,pins = <
374 pinctrl-single,pins = <
381 pinctrl-single,pins = <
407 pinctrl-single,pins = <
408 …OMAP3_CORE1_IOPAD(0x218c, PIN_INPUT | MUX_MODE4) /* mcbsp1_clkr.mcbsp1_clkr - gpio_156 FM interrup…
420 pinctrl-single,pins = <
429 pinctrl-single,pins = <
438 pinctrl-single,pins = <
447 pinctrl-names = "default";
448 pinctrl-0 = <
453 pinctrl-single,pins = <
464 pinctrl-single,pins = <
474 clock-frequency = <2600000>;
479 interrupt-parent = <&intc>;
482 clock-names = "fck";
485 compatible = "ti,twl4030-audio";
486 ti,enable-vibra = <1>;
493 compatible = "ti,twl4030-power-idle";
494 ti,system-power-controller;
503 clock-frequency = <400000>;
509 pinctrl-names = "default";
510 pinctrl-0 = <&bmp085_pins>;
511 interrupt-parent = <&gpio4>;
513 vdda-supply = <&vio>;
514 vddd-supply = <&vio>;
521 pinctrl-names = "default";
522 pinctrl-0 = <&bma180_pins>;
523 interrupt-parent = <&gpio4>;
531 pinctrl-names = "default";
532 pinctrl-0 = <&itg3200_pins>;
533 interrupt-parent = <&gpio2>;
540 #address-cells = <1>;
541 #size-cells = <0>;
544 gpio-controller;
545 #gpio-cells = <2>;
560 linux,default-trigger = "default-on";
579 pinctrl-names = "default";
580 pinctrl-0 = <&hmc5843_pins>;
581 interrupt-parent = <&gpio4>;
589 pinctrl-names = "default";
590 pinctrl-0 = <&penirq_pins>;
591 interrupt-parent = <&gpio6>;
594 ti,x-plate-ohms = <600>;
595 touchscreen-size-x = <480>;
596 touchscreen-size-y = <640>;
597 touchscreen-max-pressure = <1000>;
598 touchscreen-fuzz-x = <3>;
599 touchscreen-fuzz-y = <8>;
600 touchscreen-fuzz-pressure = <10>;
601 touchscreen-inverted-y;
612 clock-frequency = <100000>;
616 interface-type = <0>;
617 usb-phy = <&usb2_phy>;
619 phy-names = "usb2-phy";
625 port2-mode = "ehci-phy";
633 pinctrl-names = "default";
634 pinctrl-0 = <&mmc1_pins>;
635 vmmc-supply = <&vmmc1>;
636 bus-width = <4>;
637 ti,non-removable;
638 broken-cd; /* hardware has no CD */
642 vmmc-supply = <&vaux4>;
643 bus-width = <4>;
644 ti,non-removable;
645 cap-power-off-card;
646 mmc-pwrseq = <&wifi_pwrseq>;
671 pinctrl-names = "default";
672 pinctrl-0 = <&gpio1_pins>;
676 pinctrl-names = "default";
677 pinctrl-0 = <&uart1_pins>;
681 pinctrl-names = "default";
682 pinctrl-0 = <&uart2_pins>;
685 pinctrl-names = "default";
686 pinctrl-0 = <&gps_pins>;
687 sirf,onoff-gpios = <&gpio5 17 GPIO_ACTIVE_HIGH>;
688 lna-supply = <&vsim>;
689 vcc-supply = <&ldo_3v3>;
694 pinctrl-names = "default";
695 pinctrl-0 = <&uart3_pins>;
696 interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
700 ti,bb-uvolt = <3200000>;
701 ti,bb-uamp = <150>;
706 regulator-min-microvolt = <2500000>;
707 regulator-max-microvolt = <3000000>;
712 regulator-min-microvolt = <2800000>;
713 regulator-max-microvolt = <2800000>;
714 regulator-always-on; /* we should never switch off while vio is on! */
719 regulator-min-microvolt = <2500000>;
720 regulator-max-microvolt = <2500000>;
725 regulator-min-microvolt = <2800000>;
726 regulator-max-microvolt = <3150000>;
731 regulator-min-microvolt = <2800000>;
732 regulator-max-microvolt = <3150000>;
738 regulator-always-on;
742 pinctrl-names = "default";
743 pinctrl-0 = < &dss_dpi_pins >;
746 vdds_dsi-supply = <&vpll2>;
750 remote-endpoint = <&lcd_in>;
751 data-lines = <24>;
759 vdda-supply = <&vdac>;
763 remote-endpoint = <&opa_in>;
765 ti,invert-polarity;
774 compatible = "ti,omap2-nand";
776 interrupt-parent = <&gpmc>;
779 ti,nand-ecc-opt = "ham1";
780 rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
781 nand-bus-width = <16>;
782 #address-cells = <1>;
783 #size-cells = <1>;
785 gpmc,device-width = <2>;
786 gpmc,cs-on-ns = <0>;
787 gpmc,cs-rd-off-ns = <44>;
788 gpmc,cs-wr-off-ns = <44>;
789 gpmc,adv-on-ns = <6>;
790 gpmc,adv-rd-off-ns = <34>;
791 gpmc,adv-wr-off-ns = <44>;
792 gpmc,oe-off-ns = <54>;
793 gpmc,we-off-ns = <40>;
794 gpmc,access-ns = <64>;
795 gpmc,rd-cycle-ns = <82>;
796 gpmc,wr-cycle-ns = <82>;
797 gpmc,wr-access-ns = <40>;
798 gpmc,wr-data-mux-bus-ns = <0>;
799 gpmc,sync-clk-ps = <0>;
801 x-loader@0 {
802 label = "X-Loader";
807 label = "U-Boot";
812 label = "U-Boot Env";
830 #sound-dai-cells = <0>;
831 pinctrl-names = "default";
832 pinctrl-0 = <&mcbsp1_pins>;
837 pinctrl-names = "default";
838 pinctrl-0 = <&mcbsp2_pins>;
843 #sound-dai-cells = <0>;
844 pinctrl-names = "default";
845 pinctrl-0 = <&mcbsp3_pins>;
850 #sound-dai-cells = <0>;
851 pinctrl-names = "default";
852 pinctrl-0 = <&mcbsp4_pins>;
856 pinctrl-names = "default";
857 pinctrl-0 = <&hdq_pins>;
866 ti,isp-clock-divisor = <1>;
867 ti,strobe-mode;
868 bus-width = <8>;/* Used data lines */
869 data-shift = <2>; /* Lines 9:2 are used */
870 hsync-active = <0>; /* Active low */
871 vsync-active = <1>; /* Active high */
872 data-active = <1>;/* Active high */
873 pclk-sample = <1>;/* Falling */