Lines Matching +full:mpr121 +full:- +full:touchkey
1 // SPDX-License-Identifier: GPL-2.0+
6 /dts-v1/;
7 #include <dt-bindings/input/input.h>
12 compatible = "fsl,imx53-smd", "fsl,imx53";
19 gpio-keys {
20 compatible = "gpio-keys";
22 key-volume-up {
28 key-volume-down {
37 pinctrl-names = "default";
38 pinctrl-0 = <&pinctrl_esdhc1>;
39 cd-gpios = <&gpio3 13 GPIO_ACTIVE_LOW>;
40 wp-gpios = <&gpio4 11 GPIO_ACTIVE_HIGH>;
45 pinctrl-names = "default";
46 pinctrl-0 = <&pinctrl_esdhc2>;
47 non-removable;
52 pinctrl-names = "default";
53 pinctrl-0 = <&pinctrl_uart3>;
54 uart-has-rtscts;
59 pinctrl-names = "default";
60 pinctrl-0 = <&pinctrl_ecspi1>;
61 cs-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>, <&gpio3 19 GPIO_ACTIVE_LOW>;
66 spi-max-frequency = <8000000>;
71 #address-cells = <1>;
72 #size-cells = <1>;
73 compatible = "st,m25p32", "st,m25p", "jedec,spi-nor";
74 spi-max-frequency = <20000000>;
78 label = "U-Boot";
80 read-only;
91 pinctrl-names = "default";
92 pinctrl-0 = <&pinctrl_esdhc3>;
93 non-removable;
98 pinctrl-names = "default";
99 pinctrl-0 = <&pinctrl_hog>;
101 imx53-smd {
239 pinctrl-names = "default";
240 pinctrl-0 = <&pinctrl_uart1>;
245 pinctrl-names = "default";
246 pinctrl-0 = <&pinctrl_uart2>;
251 pinctrl-names = "default";
252 pinctrl-0 = <&pinctrl_i2c2>;
265 touchkey: mpr121@5a { label
266 compatible = "fsl,mpr121";
272 pinctrl-names = "default";
273 pinctrl-0 = <&pinctrl_i2c1>;
284 pinctrl-names = "default";
285 pinctrl-0 = <&pinctrl_ov5642>;
286 assigned-clocks = <&clks IMX5_CLK_SSI_EXT1_SEL>,
288 assigned-clock-parents = <&clks IMX5_CLK_PLL2_SW>,
290 assigned-clock-rates = <0>, <24000000>;
292 clock-names = "xclk";
293 DVDD-supply = <&ldo9_reg>;
294 AVDD-supply = <&ldo7_reg>;
295 reset-gpios = <&gpio6 9 GPIO_ACTIVE_LOW>;
296 powerdown-gpios = <&gpio6 10 GPIO_ACTIVE_HIGH>;
300 remote-endpoint = <&ipu_csi0_from_parallel_sensor>;
301 bus-width = <8>;
302 hsync-active = <1>;
303 vsync-active = <1>;
311 interrupt-parent = <&gpio7>;
316 regulator-min-microvolt = <1200000>;
317 regulator-max-microvolt = <3600000>;
321 regulator-min-microvolt = <1250000>;
322 regulator-max-microvolt = <3650000>;
329 pinctrl-names = "default";
330 pinctrl-0 = <&pinctrl_fec>;
331 phy-mode = "rmii";
332 phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
337 remote-endpoint = <&ov5642_to_ipu_csi0>;
338 data-shift = <12>; /* Lines 19:12 used */
339 hsync-active = <1>;
340 vsync-active = <1>;
344 pinctrl-names = "default";
345 pinctrl-0 = <&pinctrl_ipu_csi0>;