Lines Matching +full:imx53 +full:- +full:vpu
1 // SPDX-License-Identifier: GPL-2.0+
6 #include "imx53.dtsi"
10 stdout-path = &uart1;
20 compatible = "fsl,imx-parallel-display";
21 pinctrl-names = "default";
22 pinctrl-0 = <&pinctrl_ipu_disp0>;
24 #address-cells = <1>;
25 #size-cells = <0>;
32 remote-endpoint = <&ipu_di0_disp0>;
40 remote-endpoint = <&panel_in>;
45 gpio-keys {
46 compatible = "gpio-keys";
48 key-power {
54 key-volume-up {
58 wakeup-source;
61 key-volume-down {
65 wakeup-source;
70 compatible = "gpio-leds";
71 pinctrl-names = "default";
72 pinctrl-0 = <&led_pin_gpio7_7>;
74 led-user {
77 linux,default-trigger = "heartbeat";
86 remote-endpoint = <&display_out>;
92 compatible = "simple-bus";
93 #address-cells = <1>;
94 #size-cells = <0>;
97 compatible = "regulator-fixed";
99 regulator-name = "3P2V";
100 regulator-min-microvolt = <3200000>;
101 regulator-max-microvolt = <3200000>;
102 regulator-always-on;
106 compatible = "regulator-fixed";
108 regulator-name = "usb_vbus";
109 regulator-min-microvolt = <5000000>;
110 regulator-max-microvolt = <5000000>;
112 enable-active-high;
117 compatible = "fsl,imx53-qsb-sgtl5000",
118 "fsl,imx-audio-sgtl5000";
119 model = "imx53-qsb-sgtl5000";
120 ssi-controller = <&ssi2>;
121 audio-codec = <&sgtl5000>;
122 audio-routing =
126 mux-int-port = <2>;
127 mux-ext-port = <5>;
133 operating-points = <
143 pinctrl-names = "default";
144 pinctrl-0 = <&pinctrl_esdhc1>;
145 cd-gpios = <&gpio3 13 GPIO_ACTIVE_LOW>;
150 remote-endpoint = <&display0_in>;
158 pinctrl-names = "default";
159 pinctrl-0 = <&pinctrl_esdhc3>;
160 cd-gpios = <&gpio3 11 GPIO_ACTIVE_LOW>;
161 wp-gpios = <&gpio3 12 GPIO_ACTIVE_HIGH>;
162 bus-width = <8>;
167 pinctrl-names = "default";
168 pinctrl-0 = <&pinctrl_hog>;
170 imx53-qsb {
295 pinctrl_vga_sync: vgasync-grp {
313 pinctrl-names = "default";
314 pinctrl-0 = <&pinctrl_vga_sync>;
315 ddc-i2c-bus = <&i2c2>;
316 fsl,tve-mode = "vga";
317 fsl,hsync-pin = <7>; /* IPU DI1 PIN7 via EIM_OE */
318 fsl,vsync-pin = <8>; /* IPU DI1 PIN8 via EIM_RW */
323 pinctrl-names = "default";
324 pinctrl-0 = <&pinctrl_uart1>;
329 pinctrl-names = "default";
330 pinctrl-0 = <&pinctrl_i2c2>;
336 pinctrl-names = "default";
337 pinctrl-0 = <&pinctrl_codec>;
338 #sound-dai-cells = <0>;
339 VDDA-supply = <®_3p2v>;
340 VDDIO-supply = <®_3p2v>;
346 pinctrl-names = "default";
347 pinctrl-0 = <&pinctrl_i2c1>;
357 pinctrl-names = "default";
358 pinctrl-0 = <&pinctrl_audmux>;
363 pinctrl-names = "default";
364 pinctrl-0 = <&pinctrl_fec>;
365 phy-mode = "rmii";
366 phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
374 &vpu {
379 vbus-supply = <®_usb_vbus>;