Lines Matching full:default
11 - 0 - disabled (default)
17 parameters to their default state (RFC1122 for hosts, RFC1812
21 Default value of TTL field (Time To Live) for outgoing (but not
23 Default: 64 (as recommended by RFC1700)
50 Default: FALSE
53 default 552 - minimum Path MTU. Unless this is changed mannually,
57 By default we don't trust protocol path MTUs while forwarding
65 Default: 0 (disabled)
78 Default: 0
86 Default: 0 (disabled)
97 Default: 0 (Layer 3)
132 Default: 0x0007 (source IP, destination IP and IP protocol)
138 Default: 512kB Minimum: 64kB Maximum: 64MB
145 Default: 1 (Update priority.)
159 neigh/default/gc_thresh1 - INTEGER
163 Default: 128
165 neigh/default/gc_thresh2 - INTEGER
170 Default: 512
172 neigh/default/gc_thresh3 - INTEGER
177 Default: 1024
179 neigh/default/unres_qlen_bytes - INTEGER
186 Default: SK_WMEM_MAX, (same as net.core.wmem_default).
192 neigh/default/unres_qlen - INTEGER
198 Prior to linux 3.3, the default value is 3 which may cause
199 unexpected packet loss. The current default value is calculated
200 according to default value of unres_qlen_bytes and true size of
203 Default: 101
205 neigh/default/interval_probe_time_ms - INTEGER
209 Default: 5000
231 Default: 0 (Do not emit notifications.)
274 Default: 64
281 Default: 0
314 reset them. Default state is FALSE. It means that if overflow
327 Default: 1
334 Default is "reno" and the default setting (tcp_congestion_control).
340 Default: 31
351 Default : 1
367 Default : 48
376 Default : 48 (at least 8 bytes of payload per segment)
382 Default is set as part of kernel configuration.
401 Default: 3
420 Default: 2
430 Default: 1 (fallback enabled)
445 Default: 60 seconds
454 By default it's enabled with a non-zero value. 0 disables F-RTO.
465 Default: 0
487 Default: 500 (milliseconds).
491 Default: 2hours.
495 connection is broken. Default value: 9.
500 after probes started. Default value: 75sec i.e. connection
511 Default: 0 (disabled)
523 if network conditions require more than default value,
548 if network conditions require more than default value.
573 Default: 300
579 default.
586 - 1 - Disabled by default, enabled when an ICMP black hole detected
591 Discovery reprobe. The default is reprobing every 10 minutes as
596 will stop in respect to the width of search range in bytes. Default
600 By default, TCP saves various connection metrics in the route cache
610 Default is 1, which disables ssthresh metrics.
617 The default value is 8.
637 Default: 0x1
647 Default: 0 (disabled)
654 Default: 3
661 Default: 300
675 default.
684 The default value of 15 yields a hypothetical timeout of 924.6
697 Default: 0
699 tcp_rmem - vector of 3 INTEGERs: min, default, max
704 Default: 4K
706 default: initial size of receive buffer used by TCP sockets.
708 Default: 131072 bytes.
716 Default: between 131072 and 6MB, depending on RAM size.
724 The default is 1ms, based on TSO autosizing period.
726 Default : 1,000,000 ns (1 ms)
734 Default : 100,000 ns (100 us)
740 Default : 44
748 Default: 1
755 Default: FALSE
759 be retransmitted. Should not be higher than 255. Default value
768 Default: 1
812 Default: 0
818 The client support is enabled by flag 0x1 (on by default). The client
822 The server support is enabled by flag 0x2 (off by default). Then
838 default without explicit TCP_FASTOPEN socket option.
841 Default: 0x1
854 By default, it is set to 0 (feature is disabled).
878 will be retransmitted. Should not be higher than 127. Default value
891 Default: 1
902 Default: 2
925 Default: 9 (2^9 = 512 usec)
934 Default: 200
942 Default: 120
950 Default: 3
963 Default: 2
968 tcp_wmem - vector of 3 INTEGERs: min, default, max
972 Default: 4K
974 default: initial size of send buffer used by TCP sockets. This
979 Default: 16K
987 Default: between 64K and 4MB, depending on RAM size.
1000 Default: UINT_MAX (0xFFFFFFFF)
1008 Default: 0
1021 Default: 0
1033 Default: 1048576 (16 * 65536)
1041 Default: INT_MAX (unlimited)
1065 Note also that the default value of tcp_max_tw_buckets and
1070 Default: 0
1082 Default: 0 (disabled)
1093 Default is calculated at boot time from amount of available memory.
1100 Default: 4K
1115 Default: 1 (enabled)
1127 Default: 1
1137 Default: 10
1145 Default: 0
1155 Default: 0
1167 The default values are 32768 and 60999 respectively.
1200 Default: Empty
1209 Default: 1024
1215 Default: 0
1218 By default, bind() does not select the ports automatically even if
1224 Default: 0
1232 Default: 0
1242 Default: 1
1246 The default is "1 0", meaning, that nobody (not even root) may
1254 Default: 1
1260 Default: 1
1266 Default: 0
1272 Default: 0
1278 Default: 1
1288 Default: 1000
1296 Default: 1000
1303 Default: 50
1310 Default mask: 0000001100000011000 (6168)
1330 .. [1] These are rate limited by default (see default mask above)
1338 Default: 1
1355 Default: 0
1359 Default: 20
1383 Default: 10
1388 Default: 2 (as specified by RFC2236 8.1)
1393 - 0 - (default) No enforcement of a IGMP version, IGMPv1/v2 fallback
1400 - 3 - Enforce to use IGMP version 3. The same react with default 0.
1407 this value as default 0 is recommended.
1436 default:
1455 The default value 0 means that the device is the only interface
1498 default TRUE
1511 default TRUE
1520 Default: TRUE
1529 default FALSE
1538 default
1547 default FALSE
1553 default FALSE
1560 By default failed packets are discarded.
1573 Default value is 0. Note that some distributions enable it
1593 Default value is 0.
1603 - 0 - (default) The kernel can respond to arp requests with addresses
1619 - 0 - (default) Use any local address, configured on any interface
1650 - 0 - (default): reply for any local target IP address, configured
1669 0 (default): do nothing
1695 remain as the default (1).
1697 - 1 - (default): Clear the ARP cache on NOCARRIER events
1728 Default: 10000 (10 seconds)
1734 Default: 1000 (1 seconds)
1749 1122, but is disabled by default for compatibility reasons.
1751 Default: off (0)
1758 Default: off (0)
1764 Default value is 0.
1776 Default TRUE
1798 Default value for IPV6_V6ONLY socket option,
1805 Default: FALSE (as specified in RFC3493)
1815 Default: TRUE
1825 1 automatic flow labels are enabled by default, they can be
1834 Default: 1
1844 Default: true
1866 Default: 0
1871 Default: 0 (Layer 3)
1906 Default: 0x0007 (source IP, destination IP and IP protocol)
1915 Default: FALSE
1922 Default: 1 (as specified in RFC7217)
1928 Default: 3 (as specified in RFC7217)
1933 Default: 2 (as specified by RFC3810 9.1)
1943 Default: 8
1951 Default: 8
1957 Default: INT_MAX (unlimited)
1963 Default: INT_MAX (unlimited)
1968 generate this message; IPv6 does by default. Setting this sysctl
1972 Default: false (generate message)
1977 default which means route dumps and notifications contain the new
1984 Default: true (backward compat mode)
1999 Default: 0 (Do not emit notifications.)
2013 Default: 0xFFFFFF
2022 Default: 0xFFFFFFFFFFFFFF
2038 ``conf/default/*``:
2039 Change the interface-specific default settings.
2050 Changing this value is same as changing ``conf/default/disable_ipv6``
2079 Default: 0
2104 Functional default:
2110 Learn default router in Router Advertisement.
2112 Functional default:
2118 Route metric for default route learned in Router Advertisement. This value
2119 will be assigned as metric for the default route learned via IPv6 Router
2125 Default: IP6_RT_PRIO_USER i.e. 1024.
2131 Default is to NOT accept these as it may be an un-intended
2134 Functional default:
2147 Default: 1
2152 Functional default:
2163 Functional default:
2174 Functional default:
2182 Functional default:
2191 Functional default:
2199 Functional default:
2210 Default: 0
2216 Functional default:
2224 Default: 1
2241 By default, Host behaviour is assumed. This means:
2244 2. If accept_ra is TRUE (default), transmit Router
2246 3. If accept_ra is TRUE (default), accept Router
2248 4. If accept_redirects is TRUE (default), accept Redirects.
2260 Default: 0 (disabled) if global forwarding is disabled (default),
2264 Default Hop Limit to set.
2266 Default: 64
2269 Default Maximum Transfer Unit
2271 Default: 1280 (IPv6 required minimum)
2277 Default: 0
2283 Default: 60
2289 Default: 1
2294 Default: 4
2300 Default: 3
2307 Default: false
2318 Default:
2326 Default: 172800 (2 days)
2331 Default: 86400 (1 day)
2338 * 0 : system default
2341 Default: 0 (addresses are removed)
2349 Default: 600
2355 Default: 5
2363 Default: 16
2370 Default: FALSE (enable IPv6 operation)
2386 1 Enable DAD (default)
2398 Default: FALSE
2416 * 0 - (default): do nothing
2421 The IPv6 Traffic Class to use by default when sending IPv6 Neighbor
2428 * 0 - (default)
2434 In most cases this should remain as the default (1).
2436 - 1 - (default): Clear neighbor discover cache on NOCARRIER events.
2443 Default: 10000 (10 seconds)
2449 Default: 1000 (1 second)
2452 * 0 - (default) No enforcement of a MLD version, MLDv1 fallback allowed
2460 * 1 - (default) discard fragmented neighbor discovery packets
2466 * 0: disabled (default)
2479 * 0: disabled (default)
2489 be stable privacy ones by default. This can be changed via the
2490 addrgenmode ip-link. conf/default/stable_secret is used as the
2497 By default the stable secret is unset.
2503 0 generate address based on EUI64 (default)
2515 By default this is turned off.
2522 By default this is turned off.
2528 - 0 - (default) Do not accept unsolicited and untracked neighbor
2563 Default: TRUE
2574 Default: 1000
2589 Default: 0-1,3-127 (rate limit ICMPv6 errors except Packet Too Big)
2595 Default: 0
2601 Default: 0
2607 Default: 0
2628 Default: 1
2634 Default: 1
2640 Default: 1
2646 Default: 0
2652 Default: 0
2664 Default: 0
2679 Default: 0
2698 Default: 1
2720 Default: 0
2740 Default: 0
2751 Default: 0
2760 Default: 1
2766 Default: 4
2773 Default: 10
2780 Default: 8
2788 Default: 5
2804 Default: 0
2813 is disabled by initializing 'ps_retrans' per netns as 0xffff by default,
2816 Default: 0xffff
2823 Default: 3000
2829 Default: 60000
2835 Default: 1000
2842 Default: 30000
2848 Default: 200
2851 The default lifetime of the SCTP cookie (in milliseconds). The cookie
2854 Default: 60000
2863 Default: 1
2878 Default: Dependent on configuration. MD5 if available, else SHA1 if
2895 Default: 0
2903 Default: 0
2916 Default is calculated at boot time from amount of available memory.
2918 sctp_rmem - vector of 3 INTEGERs: min, default, max
2919 Only the first value ("min") is used, "default" and "max" are
2926 Default: 4K
2928 sctp_wmem - vector of 3 INTEGERs: min, default, max
2929 Only the first value ("min") is used, "default" and "max" are
2936 Default: 4K
2946 Default: 1
2961 Default: 0
2964 The default remote UDP encapsulation port.
2967 outgoing UDP-encapsulated SCTP packets by default. Users can also
2977 Default: 0
2989 Default: 0
3000 Default: 0
3014 Default: 0
3026 Default: 1
3041 Default: 10