Lines Matching full:temperature

95 The chips support up to 25 temperature monitoring sources. Up to 6 of those are
96 direct temperature sensor inputs, the others are special sources such as PECI,
97 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
104 The temperature sensor sources on all chips are configurable. The configured
105 source for each of the temperature sensors is provided in tempX_label.
108 either 1 degC or 0.5 degC, depending on the temperature source and
109 configuration. An alarm is triggered when the temperature gets higher than
110 the high limit; it stays on until the temperature falls below the hysteresis
128 In this mode, the chip attempts to keep the measured temperature in a
129 predefined temperature range. If the temperature goes out of range, fan
143     - this file controls mode of fan/temperature control:
162 			Temperature source. Value is temperature sensor index.
166 			Secondary temperature source. Value is temperature
168 			Set to 0 to disable secondary temperature control.
170 If secondary temperature functionality is enabled, it is controlled with the
177 			Temperature step size. With each step over
182 			Temperature at which secondary temperature control kicks
186 			Temperature step tolerance.
191 If the temperature is in the range defined by:
194 			Target temperature, unit millidegree Celsius
198 			Target temperature tolerance, unit millidegree Celsius
200 There are no changes to fan speed. Once the temperature leaves the interval, fan
201 speed increases (if temperature is higher that desired) or decreases (if
202 temperature is lower than desired), using the following limits and time
207 			when the temperature is above defined range.
210 			lowest fan pwm (range 0 - 255) if temperature is below
212 			stop if the temperature is below the defined range.
222 			corresponding fan off (when the temperature was below
243 controlled by setting the pwm and temperature attributes. When the temperature
247 higher fan speeds with increasing temperature. The last data point reflects
248 critical temperature mode, in which the fans should run at full speed.
251 			pwm value to be set if temperature reaches matching
252 			temperature range.
255 			Temperature over which the matching pwm is enabled.
258 			Temperature tolerance, unit millidegree Celsius
261 			Temperature tolerance for critical temperature,
275 temperature measurement device. As a result, the temperature reported on CPUTIN
277 temperatures, and in some cases the reported temperature declines if the actual
278 temperature increases (similar to the raw PECI temperature value - see PECI
280 boards. The CPU temperature on ASUS boards is reported from PECI 0.