Lines Matching +full:hardware +full:- +full:triggered
10 Addresses scanned: I2C 0x2c - 0x2e
18 Addresses scanned: I2C 0x2c - 0x2e
24 - Frodo Looijaard <frodol@dds.nl>,
25 - Philip Edelbrock <phil@netroedge.com>,
26 - Mark Studebaker <mdsxyz123@yahoo.com>,
27 - Stephen Rousset <stephen.rousset@rocketlogix.com>,
28 - Dan Eaton <dan.eaton@rocketlogix.com>,
29 - Jean Delvare <jdelvare@suse.de>,
30 - Original 2.6 port Jeff Oliver
33 -----------
48 triggered if the rotation speed has dropped below a programmable limit. Fan
55 volts. An alarm is triggered if the voltage has crossed a programmable
59 If an alarm triggers, it will remain triggered until the hardware register
62 hardware registers are read whenever any data is read (unless it is less
64 miss once-only alarms.
70 Hardware Configurations
71 -----------------------
74 depending on the hardware configuration.
77 time. Which are depends on the hardware setup. This driver normally
83 - in0+in5 (default) or temp3
84 - fan1 (default) or in6
85 - fan2 (default) or in7
86 - VID lines (default) or IRQ lines (not handled by this driver)