Lines Matching +full:- +full:temperature
20 Andigilog has both the PECI and pre-PECI versions of the Heceta-6, as
21 Intel calls them. Heceta-6e has high frequency PWM and Heceta-6p has
23 Heceta-6e part and aSC7621 is the Heceta-6p part. They are both in
27 specification. First enhancement is temperature reading resolution. We
28 have used registers below 20h for vendor-specific functions in addition
29 to those in the Intel-specified vendor range.
32 The fan speed control uses this finer value to produce a "step-less" fan
33 PWM output. These two bytes are "read-locked" to guarantee that once a
34 high or low byte is read, the other byte is locked-in until after the
37 sheet says 10-bits of resolution, although you may find the lower bits
42 data sheet. Our temperature reports and fan PWM outputs are very smooth
44 temperature reports. The smoother PWM output does not require user
47 We offer GPIO features on the former VID pins. These are open-drain
49 outputs that are based on temperature limits. These are in 19h and 1Ah.
51 We offer flexible mapping of temperature readings to thermal zones. Any
52 temperature may be mapped to any zone, which has a default assignment
61 Both remote diode temperature readings may be given an offset value such
62 that the reported reading as well as the temperature used to determine
69 Intel configuration. This would be useful in multi-CPU systems with
74 fan types. We can also support pulse-stretched PWM so that 3-wire fans
81 --------------------------------------------------------------------------
87 Using a 10-bit ADC, the aSC7621 measures the temperature of two remote diode
91 Using temperature information from these four zones, an automatic fan speed
93 recommended CPU temperature under varying operational loads.
97 temperature zones. Both high- and low-frequency PWM ranges are supported.
100 temperature readings for better control of fan speed and minimum acoustic
112 --------
114 - Supports PECI interface and monitors internal and remote thermal diodes
115 - 2-wire, SMBus 2.0 compliant, serial interface
116 - 10-bit ADC
117 - Monitors VCCP, 2.5V, 3.3V, 5.0V, and 12V motherboard/processor supplies
118 - Programmable autonomous fan control based on temperature readings
119 - Noise filtering of temperature reading for fan speed control
120 - 0.25C digital temperature sensor resolution
121 - 3 PWM fan speed control outputs for 2-, 3- or 4-wire fans and up to 4 fan
123 - Enhanced measured temperature to Temperature Zone assignment.
124 - Provides high and low PWM frequency ranges
125 - 3 GPIO pins for custom use
126 - 24-Lead QSOP package
132 the standards defined in "sysfs-interface".
136 0 (default) peci_legacy = 0, Remote 1 Temperature
137 peci_legacy = 1, PECI Processor Temperature 0
138 1 Remote 1 Temperature
139 2 Remote 2 Temperature
140 3 Internal Temperature
141 4 PECI Processor Temperature 0
142 5 PECI Processor Temperature 1
143 6 PECI Processor Temperature 2
144 7 PECI Processor Temperature 3
149 0 (default) Internal Temperature
150 1 Remote 1 Temperature
151 2 Remote 2 Temperature
152 3 Internal Temperature
153 4 PECI Processor Temperature 0
154 5 PECI Processor Temperature 1
155 6 PECI Processor Temperature 2
156 7 PECI Processor Temperature 3
161 0 (default) Remote 2 Temperature
162 1 Remote 1 Temperature
163 2 Remote 2 Temperature
164 3 Internal Temperature
165 4 PECI Processor Temperature 0
166 5 PECI Processor Temperature 1
167 6 PECI Processor Temperature 2
168 7 PECI Processor Temperature 3
173 0 (default) peci_legacy = 0, PECI Processor Temperature 0
174 peci_legacy = 1, Remote 1 Temperature
175 1 Remote 1 Temperature
176 2 Remote 2 Temperature
177 3 Internal Temperature
178 4 PECI Processor Temperature 0
179 5 PECI Processor Temperature 1
180 6 PECI Processor Temperature 2
181 7 PECI Processor Temperature 3
184 temp[1-4]_smoothing_enable / temp[1-4]_smoothing_time
197 temp[1-4]_crit
198 When the corresponding zone temperature reaches this value,
201 temp[5-8]_input / temp[5-8]_enable
207 pwm[1-3]_enable
212 if the temperature for the zone is below the minimum.
214 temperature for the zone is below the minimum.
215 4-254 Ignored.
219 pwm[1-3]_auto_channels
220 Bitmap as described in sysctl-interface with the following
243 pwm[1-3]_invert
244 When set, inverts the meaning of pwm[1-3].
248 pwm[1-3]_freq
290 Temperature Zone 1, PECI is associated with
294 PECI is associated with Temperature Zone 1,