Lines Matching refs:ATAPI

12 transports for ATA and ATAPI devices, and SCSI<->ATA translation for ATA
135 Per-cmd ATAPI DMA capabilities filter
445     commands use :c:func:`ata_scsi_qc_complete` while ATAPI commands use
473 ATAPI NODATA or DMA
479 ATAPI PIO
481     in ATAPI NODATA or DMA, packet_task submits cdb. However, after
517 For all non-ATAPI commands, whether it fails or not, almost the same
522 However, failed ATAPI commands require more handling as REQUEST SENSE is
523 needed to acquire sense data. If an ATAPI command fails,
539 timeout and ATAPI error completion. This function calls low level libata
552 If EH is invoked due to a failed ATAPI qc, the qc here is completed but
630 ATA/ATAPI devices and describe how they should be handled in
658 during issuing or execution any ATA/ATAPI command.
668    is transferred. ATA/ATAPI standard states that "The device shall not
682 ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION)
685 These are errors detected and reported by ATA/ATAPI devices indicating
688 errors are detected by ATA/ATAPI devices and reported using the same
695 For ATAPI commands,
707 Of errors detected as above, the following are not ATA/ATAPI device
713     corruption occurred during data transfer. Up to ATA/ATAPI-7, the
715     transfers but ATA/ATAPI-8 draft revision 1f says that the bit may be
719     Up to ATA/ATAPI-7, the standard specifies that ABRT could be set on
722     aren't allowed to use ICRC bit up to ATA/ATAPI-7, it seems to imply
725     However, ATA/ATAPI-8 draft revision 1f removes the part that ICRC
729 ATA/ATAPI device errors can be further categorized as follows.
738     but ATA/ATAPI standard specifies that the amount of transferred data
757 up to ATA/ATAPI-7 no definition of "na" can be found. However,
758 ATA/ATAPI-8 draft revision 1f describes "N/A" as follows.
768 ATAPI device CHECK CONDITION
771 ATAPI device CHECK CONDITION error is indicated by set CHK bit (ERR bit)
795 `ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION) <#excatDevErr>`__
814    `ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION) <#excatDevErr>`__.
902 -  When it's known that HBA is in ready state but ATA/ATAPI device is in
914 OTOH, ATA/ATAPI standard describes in detail ways to reset ATA/ATAPI
931     Although ATA/ATAPI standard doesn't describe exactly, EDD implies
942 ATAPI DEVICE RESET command
967 ATA/ATAPI standard specifies that some parameters must be maintained
973 Also, ATA/ATAPI standard requires that IDENTIFY DEVICE / IDENTIFY PACKET