Lines Matching +full:mdio +full:- +full:mux +full:- +full:multiplexer
3 This binding describes the Top Level Mode Multiplexer block found in the
6 - compatible:
9 Definition: must be "qcom,ipq8074-pinctrl"
11 - reg:
13 Value type: <prop-encoded-array>
16 - interrupts:
18 Value type: <prop-encoded-array>
21 - interrupt-controller:
26 - #interrupt-cells:
30 in <dt-bindings/interrupt-controller/irq.h>
32 - gpio-controller:
37 - #gpio-cells:
41 in <dt-bindings/gpio/gpio.h>
43 - gpio-ranges:
47 - gpio-reserved-ranges:
51 Please refer to ../gpio/gpio.txt and ../interrupt-controller/interrupts.txt for
54 Please refer to pinctrl-bindings.txt in this directory for details of the
61 mux function to select on those pin(s)/group(s), and various pin configuration
62 parameters, such as pull-up, drive strength, etc.
71 other words, a subnode that lists a mux function but no pin configuration
74 information about e.g. the mux function.
77 The following generic properties as defined in pinctrl-bindings.txt are valid
80 - pins:
82 Value type: <string-array>
85 gpio0-gpio69
87 - function:
105 mdio, pcie0_clk, pcie0_rst, pcie0_wake, pcie1_clk,
118 - bias-disable:
123 - bias-pull-down:
128 - bias-pull-up:
133 - output-high:
139 - output-low:
145 - drive-strength:
154 compatible = "qcom,ipq8074-pinctrl";
157 gpio-controller;
158 #gpio-cells = <2>;
159 gpio-ranges = <&tlmm 0 0 70>;
160 interrupt-controller;
161 #interrupt-cells = <2>;
163 uart2: uart2-default {
164 mux {
171 drive-strength = <4>;
172 bias-disable;
177 drive-strength = <2>;
178 bias-pull-up;