Lines Matching +full:signal +full:- +full:group

4 - compatible: "nvidia,tegra20-pinmux"
5 - reg: Should contain the register physical address and length for each of
6   the tri-state, mux, pull-up/down, and pad control register sets.
8 Please refer to pinctrl-bindings.txt in this directory for details of the
14 pin, a group, or a list of pins or groups. This configuration can include the
15 mux function to select on those pin(s)/group(s), and various pin configuration
16 parameters, such as pull-up, tristate, drive strength, etc.
30 Required subnode-properties:
31 - nvidia,pins : An array of strings. Each string contains the name of a pin or
32     group. Valid values for these names are listed below.
34 Optional subnode-properties:
35 - nvidia,function: A string containing the name of the function to mux to the
36   pin or group. Valid values for function names are listed below. See the Tegra
37   TRM to determine which are valid for each pin or group.
38 - nvidia,pull: Integer, representing the pull-down/up to apply to the pin.
40 - nvidia,tristate: Integer.
42 - nvidia,high-speed-mode: Integer. Enable high speed mode the pins.
44 - nvidia,schmitt: Integer. Enables Schmitt Trigger on the input.
46 - nvidia,low-power-mode: Integer. Valid values 0-3. 0 is least power, 3 is
49 - nvidia,pull-down-strength: Integer. Controls drive strength. 0 is weakest.
52 - nvidia,pull-up-strength: Integer. Controls drive strength. 0 is weakest.
55 - nvidia,slew-rate-rising: Integer. Controls rising signal slew rate. 0 is
58 - nvidia,slew-rate-falling: Integer. Controls falling signal slew rate. 0 is
68 Valid values for pin and group names are:
94     With some exceptions, these support nvidia,high-speed-mode,
95     nvidia,schmitt, nvidia,low-power-mode, nvidia,pull-down-strength,
96     nvidia,pull-up-strength, nvidia,slew-rate-rising, nvidia,slew-rate-falling.
120 		compatible = "nvidia,tegra20-pinmux";
121 		reg = < 0x70000014 0x10    /* Tri-state registers */
123 			0x700000a0 0x14    /* Pull-up/down registers */
141 		pinctrl-names = "default";
142 		pinctrl-0 = <&sdio4_default>;