Lines Matching +full:drive +full:- +full:strength +full:- +full:microamp
4 - compatible: one of "amlogic,meson8-cbus-pinctrl"
5 "amlogic,meson8b-cbus-pinctrl"
6 "amlogic,meson8m2-cbus-pinctrl"
7 "amlogic,meson8-aobus-pinctrl"
8 "amlogic,meson8b-aobus-pinctrl"
9 "amlogic,meson8m2-aobus-pinctrl"
10 "amlogic,meson-gxbb-periphs-pinctrl"
11 "amlogic,meson-gxbb-aobus-pinctrl"
12 "amlogic,meson-gxl-periphs-pinctrl"
13 "amlogic,meson-gxl-aobus-pinctrl"
14 "amlogic,meson-axg-periphs-pinctrl"
15 "amlogic,meson-axg-aobus-pinctrl"
16 "amlogic,meson-g12a-periphs-pinctrl"
17 "amlogic,meson-g12a-aobus-pinctrl"
18 "amlogic,meson-a1-periphs-pinctrl"
19 "amlogic,meson-s4-periphs-pinctrl"
20 - reg: address and size of registers controlling irq functionality
22 === GPIO sub-nodes ===
24 The GPIO bank for the controller is represented as a sub-node and it acts as a
27 Required properties for sub-nodes are:
28 - reg: should contain a list of address and size, one tuple for each entry
29 in reg-names.
30 - reg-names: an array of strings describing the "reg" entries.
32 May contain "pull", "pull-enable" and "ds" when appropriate.
33 - gpio-controller: identifies the node as a gpio controller
34 - #gpio-cells: must be 2
36 === Other sub-nodes ===
38 Child nodes without the "gpio-controller" represent some desired
43 - groups: a list of pinmux groups. The list of all available groups
45 - function: the name of a function to activate for the specified set
50 - pins: a list of pin names
53 described in file pinctrl-bindings.txt:
54 - "bias-disable"
55 - "bias-pull-up"
56 - "bias-pull-down"
57 - "output-enable"
58 - "output-disable"
59 - "output-low"
60 - "output-high"
63 - drive-strength-microamp: Drive strength for the specified pins in uA.
69 compatible = "amlogic,meson8-cbus-pinctrl";
71 #address-cells = <1>;
72 #size-cells = <1>;
80 reg-names = "mux", "pull", "pull-enable", "gpio";
81 gpio-controller;
82 #gpio-cells = <2>;