Lines Matching +full:gpio +full:- +full:gate +full:- +full:clock
6 Documentation/devicetree/bindings/pci/snps,dw-pcie.yaml.
11 - compatible: Should be one of the following strings:
12 "hisilicon,hi3798cv200-pcie"
13 - reg: Should contain sysctl, rc_dbi, config registers location and length.
14 - reg-names: Must include the following entries:
16 "rc-dbi": configuration space of PCIe controller;
18 - bus-range: PCI bus numbers covered.
19 - interrupts: MSI interrupt.
20 - interrupt-names: Must include "msi" entries.
21 - clocks: List of phandle and clock specifier pairs as listed in clock-names
23 - clock-name: Must include the following entries:
24 "aux": auxiliary gate clock;
25 "pipe": pipe gate clock;
26 "sys": sys gate clock;
27 "bus": bus gate clock.
28 - resets: List of phandle and reset specifier pairs as listed in reset-names
30 - reset-names: Must include the following entries:
36 - reset-gpios: The gpio to generate PCIe PERST# assert and deassert signal.
37 - vpcie-supply: The regulator in charge of PCIe port power.
38 - phys: List of phandle and phy mode specifier, should be 0.
39 - phy-names: Must be "phy".
43 compatible = "hisilicon,hi3798cv200-pcie";
47 reg-names = "control", "rc-dbi", "config";
48 #address-cells = <3>;
49 #size-cells = <2>;
51 bus-range = <0 15>;
52 num-lanes = <1>;
56 interrupt-names = "msi";
57 #interrupt-cells = <1>;
58 interrupt-map-mask = <0 0 0 0>;
59 interrupt-map = <0 0 0 0 &gic GIC_SPI 131 IRQ_TYPE_LEVEL_HIGH>;
64 clock-names = "aux", "pipe", "sys", "bus";
66 reset-names = "soft", "sys", "bus";
68 phy-names = "phy";