Lines Matching +full:can +full:- +full:clock +full:- +full:select

7  - micrel,led-mode : LED mode value to set for PHYs with configurable LEDs.
23  - micrel,rmii-reference-clock-select-25-mhz: RMII Reference Clock Select
26 	Setting the RMII Reference Clock Select bit enables 25 MHz rather
27 	than 50 MHz clock mode.
30 	non-standard, inverted function of this configuration bit.
31 	Specifically, a clock reference ("rmii-ref" below) is always needed to
32 	actually select a mode.
34  - clocks, clock-names: contains clocks according to the common clock bindings.
37 	- KSZ8021, KSZ8031, KSZ8081, KSZ8091: "rmii-ref": The RMII reference
38 	  input clock. Used to determine the XI input clock.
40  - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode
43 	by the FXEN boot strapping pin. It can't be determined from the PHY
45 	property can be used to describe it.
47 	In fiber mode, auto-negotiation is disabled and the PHY can only work in
48 	100base-fx (full and half duplex) modes.
50  - coma-mode-gpios: If present the given gpio will be deasserted when the
54 	isolate and power-down mode. On some boards this input is connected