Lines Matching +full:nand +full:- +full:is +full:- +full:boot +full:- +full:medium

1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mtd/nand-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: NAND Chip and NAND Controller Generic Binding
10   - Miquel Raynal <miquel.raynal@bootlin.com>
11   - Richard Weinberger <richard@nod.at>
14   The NAND controller should be represented with its own DT node, and
15   all NAND chips attached to this controller should be defined as
16   children nodes of the NAND controller. This representation should be
24   The interpretation of these parameters is implementation-defined, so
31     pattern: "^nand-controller(@.*)?"
33   "#address-cells":
36   "#size-cells":
41   cs-gpios:
43       Array of chip-select available to the controller. The first
44       entries are a 1:1 mapping of the available chip-select on the
45       NAND controller (even if they are not used). As many additional
46       chip-select as needed may follow and should be phandles of GPIO
47       lines. 'reg' entries of the NAND chip subnodes become indexes of
48       this array when this property is present.
53   "^nand@[a-f0-9]$":
55     $ref: "nand-chip.yaml#"
60           Contains the chip-select IDs.
62       nand-ecc-placement:
64           Location of the ECC bytes. This location is unknown by default
71       nand-bus-width:
73           Bus width to the NAND chip
78       nand-on-flash-bbt:
83           it as the device ages. Otherwise, the out-of-band area of a
84           few pages of all the blocks will be scanned at boot time to
89       nand-ecc-maximize:
92           maximum ECC strength is both controller and chip
95           constraint into account. This is particularly useful when
96           only the in-band area is used by the upper layers, and you
97           want to make your NAND as reliable as possible.
100       nand-is-boot-medium:
102           Whether or not the NAND chip is a boot medium. Drivers might
104           the boot ROM or similar restrictions.
107       nand-rb:
110         $ref: /schemas/types.yaml#/definitions/uint32-array
112       rb-gpios:
116           Ready/Busy pins. Active state refers to the NAND ready state and
117           should be set to GPIOD_ACTIVE_HIGH unless the signal is inverted.
119       wp-gpios:
122           Active state refers to the NAND Write Protect state and should be
123           set to GPIOD_ACTIVE_LOW unless the signal is inverted.
127       - reg
130   - "#address-cells"
131   - "#size-cells"
136   - |
137     nand-controller {
138       #address-cells = <1>;
139       #size-cells = <0>;
140       cs-gpios = <0>, <&gpioA 1>; /* A single native CS is available */
144       nand@0 {
146         /* NAND chip specific properties */
149       nand@1 {