Lines Matching +full:controller +full:- +full:number

7 The Broadcom GPIO Controller IP can be configured prior to synthesis to
9 GPIO controller only supports edge, not level, triggering of interrupts.
12 -------------------
14 - compatible: "brcm,bcm11351-gpio", "brcm,kona-gpio"
15 - reg: Physical base address and length of the controller's registers.
16 - interrupts: The interrupt outputs from the controller. There is one GPIO
17   interrupt per GPIO bank. The number of interrupts listed depends on the
18   number of GPIO banks on the SoC. The interrupts must be ordered by bank,
21 - #gpio-cells: Should be <2>. The first cell is the pin number, the second
23   - bit 0 specifies polarity (0 for normal, 1 for inverted)
24   See also "gpio-specifier" in .../devicetree/bindings/gpio/gpio.txt.
25 - #interrupt-cells: Should be <2>. The first cell is the GPIO number. The
28   - trigger type (bits[1:0]):
29       1 = low-to-high edge triggered.
30       2 = high-to-low edge triggered.
31       3 = low-to-high or high-to-low edge triggered
33   See also .../devicetree/bindings/interrupt-controller/interrupts.txt.
34 - gpio-controller: Marks the device node as a GPIO controller.
35 - interrupt-controller: Marks the device node as an interrupt controller.
39 		compatible = "brcm,bcm11351-gpio", "brcm,kona-gpio";
48 		#gpio-cells = <2>;
49 		#interrupt-cells = <2>;
50 		gpio-controller;
51 		interrupt-controller;