Lines Matching full:inputs

11 Up to 64 vivid instances can be created, each with up to 16 inputs and 16 outputs.
17 These inputs and outputs act exactly as a real hardware device would behave. This
48 device with webcam, TV, S-Video and HDMI inputs, a video output device with
52 The number of instances, devices, video inputs and outputs and their types are
88 	the number of inputs, one for each instance. By default 4 inputs
89 	are created for each video capture device. At most 16 inputs can be created,
95 	what the type of each input is when the inputs are created for each driver
105 	So to create a video capture device with 8 inputs where input 0 is a TV
106 	tuner, inputs 1-3 are S-Video inputs and inputs 4-7 are HDMI inputs you
226 	Note that this value is ignored by webcam inputs: those enumerate
317 four inputs are configured: a webcam, a TV tuner, an S-Video and an HDMI
343 TV and S-Video Inputs
349 These inputs support audio inputs as well: one TV and one Line-In. They
354 These inputs support all combinations of the field setting. Special care has
395 Finally, for these inputs the v4l2_timecode struct is filled in in the
402 The HDMI inputs supports all CEA-861 and DMT timings, both progressive and
422 For HDMI inputs it is possible to set the EDID. By default a simple EDID
423 is provided. You can only set the EDID for HDMI inputs. Internally, however,
424 the EDID is shared between all HDMI inputs.
429 There is a maximum of 15 HDMI inputs (if there are more, then they will be
492 The VBI device will only work for the S-Video and TV inputs, it will give
586 back an error for all other inputs.
634 brightness range (minimum and maximum control values). Switching inputs will
1139 and VBI looping is only supported between S-Video and HDMI inputs and outputs.
1227 only applies to the TV/S-Video/HDMI inputs and outputs. The reason is that
1377 If there are HDMI inputs then a CEC adapter will be created that has
1379 has that number of inputs. Each HDMI output will also create a
1381 are more outputs than inputs) is not hooked up at all. In other words,
1388 containing physical address A.B.C.0 where C is 1 to the number of inputs. If
1389 there are more outputs than inputs then the remaining outputs have a CEC adapter