Lines Matching +full:host +full:- +full:wakeup
13 These commands are used to configure the host sleep parameters::
14 bit 8:0 -- Gap
15 bit 16:8 -- GPIO
17 where GPIO is the pin number of GPIO used to wake up the host.
18 It could be any valid GPIO pin# (e.g. 0-7) or 0xff (SDIO interface
19 wakeup will be used instead).
21 where Gap is the gap in milli seconds between wakeup signal and
22 wakeup event, or 0xff for special host sleep setting.
26 # Use SDIO interface to wake up the host and set GAP to 0x80:
30 # Use GPIO pin #3 to wake up the host and set GAP to 0xff:
39 1 -- Enable auto sleep mode
40 0 -- Disable auto sleep mode
54 These commands are used to enable host sleep or wake up firmware
58 1 -- Enable host sleep
59 0 -- Wake up firmware
63 # Enable host sleep
90 This command display the host sleep state.
106 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x00 --Enable All interface
107 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x01 --Enable Wlan interface
108 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x02 --Enable BT interface
109 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x00 --Disable All interface
110 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x01 --Disable Wlan interface
111 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x02 --Disable BT interface
118 - /lib/firmware/sd8688_helper.bin
119 - /lib/firmware/sd8688.bin
124 git.infradead.org/users/dwmw2/linux-firmware.git/libertas/