Lines Matching +full:current +full:- +full:mode

20 		supplying power to the system (unless some non-Linux
33 		"status". This reports the current regulator status, for
38 			- off
39 			- on
40 			- error
41 			- fast
42 			- normal
43 			- idle
44 			- standby
50 		and the regulator can't report a detailed operation mode.
52 		"error" indicates an out-of-regulation status such as being
77 		- 'voltage'
78 		- 'current'
79 		- 'unknown'
84 		'current' means the regulator output current limit can be
88 		current limit.
98 		measured in microvolts (i.e. E-6 Volts), for regulators
112 		microamps. This holds the regulator output current limit
113 		setting measured in microamps (i.e. E-6 Amps), for regulators
114 		which can report the control input for a current limit.
117 		output current level as this value is the same regardless of
127 		opmode. This holds the current regulator operating mode,
132 		- 'fast'
133 		- 'normal'
134 		- 'idle'
135 		- 'standby'
136 		- 'unknown'
141 		output operating mode as this value is the same regardless of
143 		attribute may be available to determine the actual mode.
183 		output current limit setting for this domain measured in
184 		microamps, for regulators which support current constraints.
198 		output current limit setting for this domain measured in
199 		microamps, for regulators which support current constraints.
236 		current in microamps for this regulator from all its consumer
287 		suspend_mem_mode. This holds the regulator operating mode
289 		memory, for regulators implementing suspend mode
298 		suspend_disk_mode. This holds the regulator operating mode
300 		for regulators implementing suspend mode configuration
309 		suspend_standby_mode. This holds the regulator operating mode
311 		standby, for regulators implementing suspend mode
359 		bypass.  This indicates if the device is in bypass mode.
363 		- 'enabled'
364 		- 'disabled'
365 		- 'unknown'
367 		'enabled' means the regulator is in bypass mode.
381 		under-voltage fault (1) or not (0).
390 		over-current fault (1) or not (0).
399 		out-of-regulation fault (1) or not (0).
417 		over-temperature fault (1) or not (0).
426 		under-voltage warning (1) or not (0).
435 		over-current warning (1) or not (0).
444 		over-voltage warning (1) or not (0).
453 		over-temperature warning (1) or not (0).