Lines Matching full:signal

124 			Rising edges on signal A updates the respective count.
125 			The input level of signal B determines direction.
129 			signal A updates the respective count; if the direction
130 			is backward, falling edges on quadrature pair signal A
136 			signal B updates the respective count; if the direction
137 			is backward, falling edges on quadrature pair signal B
142 			Any state transition on quadrature pair signal A updates
147 			Any state transition on quadrature pair signal B updates
193 		Action mode of Count Y for Signal Z. This attribute indicates
194 		the condition of Signal Z that triggers the count function
199 			Signal does not trigger the count function. In
200 			Pulse-Direction count function mode, this Signal is
288 		for the respective channel of Signal Y. Valid attribute values
297 		respective channel of Signal Y is enabled. Valid attribute
304 		Filter clock factor for input Signal Y. This prescaler value
311 		Active level of index input Signal Y; irrelevant in
319 		Discrete set of available values for the respective Signal Y
326 		Active level of Signal Y. The following polarity values are
330 			Signal high state considered active level (rising edge).
333 			Signal low state considered active level (falling edge).
340 		Signal Y. If possible, this should match the name of the
341 		respective signal as it appears in the device datasheet.
343 What:		/sys/bus/counter/devices/counterX/signalY/signal
347 		Signal level state of Signal Y. The following signal level
360 		Configure the counter associated with Signal Y for
382 		Read-only attribute that indicates the signal Y frequency, in Hz.