160 	/* Hold OOB state machine in reset */  in sci_phy_link_layer_initialization()
541 		/* Release the spinup hold state and reset the OOB state machine */  in sci_phy_consume_power_handler()
550 		/* Now restart the OOB operation */  in sci_phy_consume_power_handler()
703 		       /* Start the oob/sn state machine over again */  in sci_phy_event_handler()
736 			 * continue OOB/SN as if this were a SATA PHY */  in sci_phy_event_handler()
750 		       /* Start the oob/sn state machine over again */  in sci_phy_event_handler()
767 			 * SATA PHY event continue OOB/SN as if this were a  in sci_phy_event_handler()
776 			/* Start the oob/sn state machine over again */  in sci_phy_event_handler()
783 			/* Start the oob/sn state machine over again */  in sci_phy_event_handler()
821 			/* There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
853 			/* There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
894 			 * There has been a change in the phy type before OOB/SN for the  in sci_phy_event_handler()
1206 	/** Reset OOB sequence - start */  in scu_link_layer_start_oob()
1213 	/** Reset OOB sequence - end */  in scu_link_layer_start_oob()
1215 	/** Start OOB sequence - start */  in scu_link_layer_start_oob()
1220 	/** Start OOB sequence - end */  in scu_link_layer_start_oob()
1227  * hardware requires that we reset the OOB state machine and set the hard reset
1228  * bit in the phy configuration register. We then must start OOB over with the
1248 	/* Now take the OOB state machine out of reset */  in scu_link_layer_tx_hard_reset()