Lines Matching +full:phy +full:- +full:is +full:- +full:integrated
1 # SPDX-License-Identifier: GPL-2.0-only
3 # PHY Layer Configuration
18 This internal symbol is used for link time dependencies and it
19 reflects whether the mdio_bus/mdio_device code is built as a
20 loadable module or built-in.
30 controllers found in the ASPEED AST2600 SoC. This is a driver for the
31 third revision of the ASPEED MDIO register interface - the first two
35 AST2500 SoCs, so say N if AST2600 support is not required.
69 to a parent bus. Switching between child busses is done by
91 selection is under the control of GPIO lines.
105 tristate "MMIO device-controlled MDIO bus multiplexers"
110 are controlled via a simple memory-mapped device, like an FPGA.
112 parent bus. Child bus selection is under the control of one of
124 that is controlled via the kernel multiplexer subsystem. The
126 a parent bus. Child bus selection is under the control of
133 tristate "GPIO lib-based bitbanged MDIO buses"
136 ---help---
137 Supports GPIO lib-based MDIO busses.
140 will be called mdio-gpio.
157 This is library mode.
180 buses. It is required by the Octeon and ThunderX ethernet device
202 tristate "APM X-Gene SoC MDIO bus controller"
206 APM X-Gene SoC's.
217 PHYlink models the link between the PHY and MAC, allowing fixed
222 tristate "PHY Device support and infrastructure"
226 Ethernet controllers are usually attached to PHY
228 managing PHY devices.
238 ---help---
239 Adds support for a set of LED trigger events per-PHY. Link
242 supported by the PHY and also a one common "link" trigger as a
243 logical-or of all the link speed ones.
245 <mii bus id>:<phy>:<speed>
247 Where speed is in the form:
249 for any speed known to the PHY.
252 comment "MII PHY device drivers"
265 - ADIN1200 - Robust,Industrial, Low Power 10/100 Ethernet PHY
266 - ADIN1300 - Robust,Industrial, Low Latency 10/100/1000 Gigabit
267 Ethernet PHY
271 ---help---
276 ---help---
282 Currently supports the Asix Electronics PHY found in the X-Surf 100
287 ---help---
291 tristate "Broadcom 63xx SOCs internal PHY"
294 ---help---
300 ---help---
310 tristate "Broadcom Cygnus/Omega SoC internal PHY"
314 ---help---
315 This PHY driver is for the 1G internal PHYs of the Broadcom
318 Currently supports internal PHY's used in the BCM11300,
328 ---help---
334 ---help---
338 tristate "Cortina EDC CDR 10G Ethernet PHY"
339 ---help---
340 Currently supports the CS4340 phy.
344 ---help---
348 tristate "Texas Instruments DP83822 PHY"
349 ---help---
350 Supports the DP83822 PHY.
353 tristate "Texas Instruments DP83TC822 PHY"
354 ---help---
355 Supports the DP83TC822 PHY.
358 tristate "Texas Instruments DP83848 PHY"
359 ---help---
360 Supports the DP83848 PHY.
363 tristate "Texas Instruments DP83867 Gigabit PHY"
364 ---help---
365 Currently supports the DP83867 PHY.
368 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
371 ---help---
375 Currently tested with mpc866ads and mpc8349e-mitx.
379 ---help---
384 ---help---
387 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel
391 tristate "LSI ET1011C PHY"
392 ---help---
393 Supports the LSI ET1011C PHY.
397 ---help---
402 ---help---
407 ---help---
411 tristate "Amlogic Meson GXL Internal PHY"
413 ---help---
414 Currently has a driver for the Amlogic Meson GXL Internal PHY
418 ---help---
428 ---help---
433 ---help---
438 ---help---
439 Currently supports the DP83865 PHY.
444 ---help---
445 Currently supports the NXP TJA1100 and TJA1101 PHY.
449 ---help---
454 ---help---
455 Supports the Realtek 821x PHY.
459 ---help---
464 ---help---
465 Currently supports the integrated Ethernet PHY.
469 ---help---
474 ---help---
475 This is the driver for the STe100p and STe101p PHYs.
479 ---help---
484 ---help---
489 ---help---
497 tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch"