Lines Matching +full:nand +full:- +full:bus +full:- +full:width
1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * at91sam9m10g45ek.dts - Device Tree file for AT91SAM9M10G45-EK board
8 /dts-v1/;
10 #include <dt-bindings/pwm/pwm.h>
13 model = "Atmel AT91SAM9M10G45-EK";
18 stdout-path = "serial0:115200n8";
27 clock-frequency = <32768>;
31 clock-frequency = <12000000>;
43 compatible = "atmel,tcb-timer";
48 compatible = "atmel,tcb-timer";
54 pinctrl-0 =
62 phy-mode = "rmii";
71 pinctrl-names = "default";
72 pinctrl-0 = <&pinctrl_pck1_as_isi_mck &pinctrl_sensor_power &pinctrl_sensor_reset>;
73 resetb-gpios = <&pioD 12 GPIO_ACTIVE_LOW>;
74 pwdn-gpios = <&pioD 13 GPIO_ACTIVE_HIGH>;
76 clock-names = "xvclk";
77 assigned-clocks = <&pck1>;
78 assigned-clock-rates = <25000000>;
82 remote-endpoint = <&isi_0>;
83 bus-width = <8>;
98 pinctrl-0 = <
105 bus-width = <4>;
106 cd-gpios = <&pioD 10 GPIO_ACTIVE_HIGH>;
111 pinctrl-0 = <
118 bus-width = <4>;
119 cd-gpios = <&pioD 11 GPIO_ACTIVE_HIGH>;
120 wp-gpios = <&pioD 29 GPIO_ACTIVE_HIGH>;
126 pinctrl_pck1_as_isi_mck: pck1_as_isi_mck-0 {
131 pinctrl_sensor_reset: sensor_reset-0 {
136 pinctrl_sensor_power: sensor_power-0 {
142 pinctrl_board_mmc0: mmc0-board {
149 pinctrl_board_mmc1: mmc1-board {
157 pinctrl_pwm_leds: pwm-led {
167 cs-gpios = <&pioB 3 0>, <0>, <0>, <0>;
170 spi-max-frequency = <13000000>;
176 atmel,vbus-gpio = <&pioB 19 GPIO_ACTIVE_HIGH>;
185 pinctrl-names = "default";
186 pinctrl-0 = <
195 atmel,adc-ts-wires = <4>;
200 pinctrl-names = "default";
201 pinctrl-0 = <&pinctrl_isi_data_0_7>;
205 remote-endpoint = <&ov2640_0>;
206 bus-width = <8>;
207 vsync-active = <1>;
208 hsync-active = <1>;
216 pinctrl-names = "default";
217 pinctrl-0 = <&pinctrl_pwm_leds>;
221 atmel,rtt-rtc-time-reg = <&gpbr 0x0>;
239 bits-per-pixel = <32>;
240 atmel,lcdcon-backlight;
243 atmel,guard-time = <9>;
244 atmel,lcd-wiring-mode = "RGB";
246 display-timings {
247 native-mode = <&timing0>;
249 clock-frequency = <9000000>;
252 hback-porch = <1>;
253 hfront-porch = <1>;
254 vback-porch = <40>;
255 vfront-porch = <1>;
256 hsync-len = <45>;
257 vsync-len = <1>;
266 nand_controller: nand-controller {
268 pinctrl-0 = <&pinctrl_nand_cs &pinctrl_nand_rb>;
269 pinctrl-names = "default";
271 nand@3 {
273 rb-gpios = <&pioC 8 GPIO_ACTIVE_HIGH>;
274 cs-gpios = <&pioC 14 GPIO_ACTIVE_HIGH>;
275 nand-bus-width = <8>;
276 nand-ecc-mode = "soft";
277 nand-on-flash-bbt;
281 compatible = "fixed-partitions";
282 #address-cells = <1>;
283 #size-cells = <1>;
306 num-ports = <2>;
307 atmel,vbus-gpio = <&pioD 1 GPIO_ACTIVE_LOW
317 compatible = "gpio-leds";
322 linux,default-trigger = "heartbeat";
327 compatible = "pwm-leds";
332 max-brightness = <255>;
333 linux,default-trigger = "nand-disk";
339 max-brightness = <255>;
340 linux,default-trigger = "mmc0";
345 compatible = "gpio-keys";
351 wakeup-source;
358 wakeup-source;