Lines Matching refs:VF
70 For example, the following instructions will configure PF eth0 and the first VF
78 virtual function (VF). Further, this feature allows you to designate a
79 particular VF as trusted, and allows that trusted VF to request selective
82 To set a VF as trusted or untrusted, enter the following command in the
87 Once the VF is designated as trusted, use the following commands in the VM to
88 set the VF to promiscuous mode.
94 Where eth2 is a VF interface in the VM
98 Where eth2 is a VF interface in the VM
101 "off",meaning that promiscuous mode for the VF will be limited. To set the
102 promiscuous mode for the VF to true promiscuous and allow the VF to see all
115 Now add a VLAN interface on the VF interface::
119 Note that the order in which you set the VF to promiscuous mode and add the
121 this example is that the VF will get all traffic that is tagged with VLAN 100.
280 bits represents the queue number, while the next 8 bits represent which VF.
281 Note that 0 is the PF, so the VF identifier is offset by 1. For example::
286 that VF.
458 NOTE: This feature can be disabled for a specific Virtual Function (VF)::
528 "add vsi failed for VF N, aq_err 16". To workaround the issue, enable less than
718 - If a TC filter on a PF matches traffic over a VF (on the PF), that
720 not be passed on the VF. Such traffic will end up getting dropped higher