Lines Matching +full:light +full:- +full:sensor

14 -----------
16 APDS990x is a combined ambient light and proximity sensor. ALS and proximity
21 (infrared + visible light) and IR only. However, threshold comparisons happen
23 might vary quite much depending the spectrum of the light source.
36 values are known. Otherwise plain sensor default values are used.
45 -----
49 	RO - shows detected chip type and version
52 	RW - enable / disable chip. Uses counting logic
56 	RO - measured lux value
60 	RO - lux0_input max value. Actually never reaches since sensor tends
62 	     on the light spectrum etc.
65 	RW - measurement rate in Hz
68 	RO - supported measurement rates
71 	RW - calibration value. Set to neutral value by default.
76 	RO - neutral calibration value
79 	RW - HI level threshold value. All results above the value
84 	RW - LO level threshold value. All results below the value
88 	RO - measured proximity value
92 	RO - prox0_raw max value (1023)
95 	RW - enable / disable proximity - uses counting logic
100 	RW - trigger / periodic. In "trigger" mode the driver tells two possible
108 	RO - accepted values to prox0_reporting_mode (trigger, periodic)
111 	RW - threshold level which trigs proximity events.