Lines Matching refs:LED
20 The interface can support both LED and xenon flash devices. As of
30 Unsynchronised LED flash (software strobe)
33 Unsynchronised LED flash is controlled directly by the host as the
41 Synchronised LED flash (hardware strobe)
44 The synchronised LED flash is pre-programmed by the host (power and
52 LED flash as torch
55 LED flash may be used as torch in conjunction with another use case
68 Defines the mode of the flash LED, the high-power white LED attached
88 Defines the source of the flash LED strobe.
125 Intensity of the flash strobe when the flash LED is in flash mode
130 Intensity of the flash LED in torch mode
136 Intensity of the indicator LED. The indicator LED may be fully
137 independent of the flash LED. The unit should be microamps (uA) if
145 if the fault affects the flash LED. Exactly which faults have such
156 - Flash controller voltage to the flash LED has exceeded the limit
168 - Current in the LED power supply has exceeded the limit specific to
172 condition on the indicator LED.
174 - Flash controller voltage to the flash LED has been below the
181 - The temperature of the LED has exceeded its allowed upper limit.
190 charged before strobing. LED flashes often require a cooldown period