Lines Matching +full:nvmem +full:- +full:cells +full:- +full:names

1 Socionext UniPhier USB3 High-Speed (HS) PHY
5 Although the controller includes High-Speed PHY and Super-Speed PHY,
6 this describes about High-Speed PHY.
9 - compatible: Should contain one of the following:
10     "socionext,uniphier-pro4-usb3-hsphy" - for Pro4 SoC
11     "socionext,uniphier-pxs2-usb3-hsphy" - for PXs2 SoC
12     "socionext,uniphier-ld20-usb3-hsphy" - for LD20 SoC
13     "socionext,uniphier-pxs3-usb3-hsphy" - for PXs3 SoC
14 - reg: Specifies offset and length of the register set for the device.
15 - #phy-cells: Should be 0.
16 - clocks: A list of phandles to the clock gate for USB3 glue layer.
17 	According to the clock-names, appropriate clocks are required.
18 - clock-names: Should contain the following:
19     "gio", "link" - for Pro4 SoC
20     "phy", "phy-ext", "link" - for PXs3 SoC, "phy-ext" is optional.
21     "phy", "link" - for others
22 - resets: A list of phandles to the reset control for USB3 glue layer.
23 	According to the reset-names, appropriate resets are required.
24 - reset-names: Should contain the following:
25     "gio", "link" - for Pro4 SoC
26     "phy", "link" - for others
29 - vbus-supply: A phandle to the regulator for USB VBUS.
30 - nvmem-cells: Phandles to nvmem cell that contains the trimming data.
31 	Available only for HS-PHY implemented on LD20 and PXs3, and
33 - nvmem-cell-names: Should be the following names, which correspond to
34 	each nvmem-cells.
35 	All of the 3 parameters associated with the following names are
38     "rterm", "sel_t", "hs_i" - Each cell name for phy parameters
40 Refer to phy/phy-bindings.txt for the generic PHY binding properties.
44 	usb-glue@65b00000 {
45 		compatible = "socionext,uniphier-ld20-dwc3-glue",
46 			     "simple-mfd";
47 		#address-cells = <1>;
48 		#size-cells = <1>;
55 		usb_hsphy0: hs-phy@200 {
56 			compatible = "socionext,uniphier-ld20-usb3-hsphy";
58 			#phy-cells = <0>;
59 			clock-names = "link", "phy";
61 			reset-names = "link", "phy";
63 			vbus-supply = <&usb_vbus0>;
64 			nvmem-cell-names = "rterm", "sel_t", "hs_i";
65 			nvmem-cells = <&usb_rterm0>, <&usb_sel_t0>,