Lines Matching full:line
3 The HDMI CEC GPIO module supports CEC implementations where the CEC line
4 is hooked up to a pull-up GPIO line and - optionally - the HPD line is
5 hooked up to another GPIO line.
7 Please note: the maximum voltage for the CEC line is 3.63V, for the HPD and
9 when connecting them to a GPIO line.
13 - cec-gpios: gpio that the CEC line is connected to. The line should be
16 If the CEC line is associated with an HDMI receiver/transmitter, then the
21 If the CEC line is not associated with an HDMI receiver/transmitter, then
24 - hpd-gpios: gpio that the HPD line is connected to.
26 This property is optional and can be used for debugging changes on the 5V line:
28 - v5-gpios: gpio that the 5V line is connected to.
30 Example for the Raspberry Pi 3 where the CEC line is connected to
31 pin 26 aka BCM7 aka CE1 on the GPIO pin header, the HPD line is
32 connected to pin 11 aka BCM17 and the 5V line is connected to pin