Lines Matching full:interrupt

1 * Marvell MMP Interrupt controller
6 - reg : Address and length of the register set of the interrupt controller.
7   If the interrupt controller is intc, address and length means the range
8   of the whole interrupt controller. If the interrupt controller is mux-intc,
10   range of intc. mux-intc is secondary interrupt controller.
11 - reg-names : Name of the register set of the interrupt controller. It's
12   only required in mux-intc interrupt controller.
13 - interrupts : Should be the port interrupt shared by mux interrupts. It's
14   only required in mux-intc interrupt controller.
15 - interrupt-controller : Identifies the node as an interrupt controller.
16 - #interrupt-cells : Specifies the number of cells needed to encode an
17   interrupt source.
18 - mrvl,intc-nr-irqs : Specifies the number of interrupts in the interrupt
20 - mrvl,clr-mfp-irq : Specifies the interrupt that needs to clear MFP edge
24 	intc: interrupt-controller@d4282000 {
26 		interrupt-controller;
27 		#interrupt-cells = <1>;
35 		interrupt-controller;
36 		#interrupt-cells = <1>;
42 * Marvell Orion Interrupt controller
46 - #interrupt-cells: Specifies the number of cells needed to encode an
47   interrupt source. Supported value is <1>.
48 - interrupt-controller : Declare this node to be an interrupt controller.
49 - reg : Interrupt mask address. A list of 4 byte ranges, one per controller.
54 	intc: interrupt-controller {
56 		interrupt-controller;
57 		#interrupt-cells = <1>;