Lines Matching full:sgmii
60 /* SGMII */
215 /* No need to trigger re-ANEG if link speed is 2.5G or SGMII ANEG is in gpy_config_aneg()
222 /* There is a design constraint in GPY2xx device where SGMII AN is in gpy_config_aneg()
225 * again, SGMII AN is not triggered and hence no new in-band message in gpy_config_aneg()
226 * from GPY to MAC side SGMII. in gpy_config_aneg()
228 * MAC. At this condition, once MAC side SGMII is up, MAC side SGMII in gpy_config_aneg()
234 * retriggerring SGMII AN. in gpy_config_aneg()
236 * reboot), polling of TPI link status is not needed and SGMII AN is in gpy_config_aneg()
239 * retriggering SGMII AN. Note: in case of speed change, GPY FW will in gpy_config_aneg()
240 * initiate SGMII AN. in gpy_config_aneg()
253 /* Trigger SGMII AN. */ in gpy_config_aneg()
267 /* Automatically switch SERDES interface between SGMII and 2500-BaseX in gpy_update_interface()
277 "Error: Disable of SGMII ANEG failed: %d\n", in gpy_update_interface()
286 /* Enable and restart SGMII ANEG for 10/100/1000Mbps link speed in gpy_update_interface()
294 "Error: Enable of SGMII ANEG failed: %d\n", in gpy_update_interface()