Lines Matching +full:factory +full:- +full:programmed
1 // SPDX-License-Identifier: GPL-2.0
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/clk/versaclock.h>
17 compatible = "fixed-clock";
18 #clock-cells = <0>;
19 clock-frequency = <32768>;
20 clock-output-names = "osc_32k";
24 compatible = "regulator-fixed";
25 regulator-name = "fixed-1.8V";
26 regulator-min-microvolt = <1800000>;
27 regulator-max-microvolt = <1800000>;
28 regulator-boot-on;
29 regulator-always-on;
33 compatible = "regulator-fixed";
34 regulator-name = "fixed-3.3V";
35 regulator-min-microvolt = <3300000>;
36 regulator-max-microvolt = <3300000>;
37 regulator-boot-on;
38 regulator-always-on;
42 compatible = "mmc-pwrseq-simple";
43 reset-gpios = <&pca9654 1 GPIO_ACTIVE_LOW>;
45 clock-names = "ext_clock";
46 post-power-on-delay-ms = <80>;
51 pinctrl-0 = <&avb_pins>;
52 pinctrl-names = "default";
53 phy-handle = <&phy0>;
54 rx-internal-delay-ps = <1800>;
55 tx-internal-delay-ps = <2000>;
57 clock-names = "fck", "refclk";
60 phy0: ethernet-phy@0 {
62 interrupt-parent = <&gpio2>;
64 reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
69 clock-frequency = <16666666>;
73 clock-frequency = <32768>;
78 gpio-hog;
80 output-high;
81 line-name = "usb-hub-reset";
86 pinctrl-0 = <&hscif0_pins>;
87 pinctrl-names = "default";
88 uart-has-rtscts;
92 compatible = "brcm,bcm43438-bt";
93 shutdown-gpios = <&pca9654 2 GPIO_ACTIVE_HIGH>;
94 host-wakeup-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
95 device-wakeup-gpios = <&pca9654 5 GPIO_ACTIVE_HIGH>;
97 clock-names = "extclk";
98 max-speed = <4000000>;
104 pinctrl-0 = <&hscif2_pins>;
105 pinctrl-names = "default";
110 clock-frequency = <100000>;
115 gpio-controller;
116 #gpio-cells = <2>;
117 gpio-line-names =
131 interrupt-parent = <&gpio5>;
133 interrupt-controller;
134 #interrupt-cells = <2>;
135 gpio-controller;
136 #gpio-cells = <2>;
137 gpio-line-names =
151 read-only; /* Manufacturing EEPROM programmed at factory */
163 #clock-cells = <1>;
165 clock-names = "xin";
167 assigned-clocks = <&versaclock5 1>,
172 assigned-clock-rates = <33333333>, <33333333>, <50000000>, <125000000>;
176 idt,voltage-microvolt = <1800000>;
177 idt,slew-percent = <100>;
182 idt,voltage-microvolt = <1800000>;
183 idt,slew-percent = <100>;
188 idt,voltage-microvolt = <1800000>;
189 idt,slew-percent = <100>;
194 idt,voltage-microvolt = <3300000>;
195 idt,slew-percent = <100>;
201 pinctrl-0 = <&scif_clk_pins>;
202 pinctrl-names = "default";
212 drive-strength = <24>;
218 drive-strength = <12>;
265 power-source = <1800>;
271 power-source = <1800>;
276 clock-frequency = <14745600>;
280 pinctrl-0 = <&scif2_pins>;
281 pinctrl-names = "default";
286 pinctrl-names = "default";
287 pinctrl-0 = <&sdhi2_pins>;
288 bus-width = <4>;
289 vmmc-supply = <®_3p3v>;
290 vqmmc-supply = <®_1p8v>;
291 non-removable;
292 cap-power-off-card;
293 pm-ignore-notify;
294 keep-power-in-suspend;
295 mmc-pwrseq = <&wlan_pwrseq>;
297 #address-cells = <1>;
298 #size-cells = <0>;
302 compatible = "brcm,bcm4329-fmac";
303 interrupt-parent = <&gpio1>;
305 interrupt-names = "host-wake";
310 pinctrl-0 = <&sdhi3_pins>;
311 pinctrl-1 = <&sdhi3_pins>;
312 pinctrl-names = "default", "state_uhs";
313 vmmc-supply = <®_3p3v>;
314 vqmmc-supply = <®_1p8v>;
315 bus-width = <8>;
316 mmc-hs200-1_8v;
317 no-sd;
318 no-sdio;
319 non-removable;
320 fixed-emmc-driver-type = <1>;
331 clock-frequency = <100000000>;